9069218 BB-00 Revised 02/13/18
Tools Needed Herramientas necesarias
∙Safety Glasses Lentes de seguridad
∙Phillips Screwdriver
∙3/32" or 2.5 mm Hex Key
Handle Replacement
for E-Series Hinged Inswing Patio Doors manufactured before March 2018
Thank you for choosing Andersen. / Gracias por elegir Andersen.
For questions call 1-888-888-7020. For more information and/or guides visit www.andersenwindows.com.
Please leave this guide with building owner.
Si tiene alguna pregunta llame al 1-888-888-7020. Para obtener más información y/o guías, visite www.eaglewindow.com
Deje esta guía con el dueño de la construcción.
▶Read guide from beginning to end before starting installation. Read all warnings and cautions during unit installation.
Lea completamente la guía antes de comenzar la instalación. Lea y respete todas las advertencias y precauciones durante la instalación de la unidad.
▶Check with your local building code ofcial to identify and conrm compliance with local building code requirements.
Consulte los códigos locales de construcción para identicar y conrmar que se cumplan los requisitos del código de construcción.
Interior Handle/Escutcheon Plate
Exterior Handle/Escutcheon Plate
and Keyed Lock Cylinder
Parts Included Partes incluidas
(1) Interior Handle/Escutcheon Plate Interior Handle/Escutcheon Plate
(1) Exterior Handle/Escutcheon Plate Exterior Handle/Escutcheon Plate
(1) Keyed Lock Cylinder
(1) Escutcheon Plate ScrewsLock Lever
“Andersen” and all other marks where denoted are trademarks of Andersen Corporation. ©2013-2017 Andersen Corporation. All rights reserved.
Use caution when working at elevated heights and around window and door
openings. Follow the manufacturers’ instructions for ladders and scaffolding. Failure
to do so could result in injury or death.
Follow manufacturers’ instructions for hand and power tools.
Always wear safety glasses. Failure to do so could result in
injury, product or property damage.
Remove interior handle/escutcheon plate. If replacing interior
handle/escutcheon plate, dispose of properly.
Remove interior and exterior handle/escutcheon plate and dispose of
properly.
Interior
Escutcheon
Plate
Interior
Escutcheon
Plate
Interior
Escutcheon Plate
Exterior
Escutcheon PlatePlate
Exterior
Escutcheon Plate
2
9069218
Open active door panel. Loosen handle set screw with 3/32" or 2.5 mm hex key.
2
Interior
4
Interior
6
Interior
3/32" or 2.5 mm Hex Key
Interior Handle
Remove two (2) escutcheon plate screws using a Phillips screwdriver
and dispose of properly.
If replacing exterior handle/escutcheon plate, remove exterior
handle/escutcheon plate and dispose of properly.
Line up the tail piece and apply interior and exterior
handle/escutcheon plates.
1
Interior
5
Interior
Active
Door
Panel
Escutcheon
Plate Screw
3
Interior
Phillips
Screwdriver
Tail Piece
Exterior GasketPlate
Exterior GasketPlate
3
9069218
Fasten escutcheon plate using screws provided.
Fasten escutcheon plate using saved screws.
Phillips
Screwdriver
9
Interior
Tighten handle set screw with 3/32" or 2.5 mm hex key.
Remove two (2) escutcheon plate screws and dispose of properly.
Close and lock active door panel. Check for correct lock operation.
Close and lock operating panel. Check for correct lock operation.
10
Interior
Active
Door
Panel
Check for
correct
operation.
▶Handle replacement is complete.
Hardware replacement is completed.
8
Interior
Test key in handle set. If it does not function properly, remove exterior
escutcheon plate, rotate tail piece 180° and repeat steps 6-7.
7
Interior
Key
3/32" or 2.5 mm Hex Key
Interior Handle
Tail Piece
Exterior
Escutcheon
Plate
180°
Escutcheon Plate
Screw
/
