Right Weigh 201-EBT-30B Installation guide

201-EBT-30B
Brand
Right Weigh
Model
201-EBT-30B
Type
Installation guide
INSTALLATION OVERVIEW
201-EBT-30B
This installaon overview is not a substute for reading the product manuals
WHAT’S INCLUDED
APPLICATIONS
Trailer Axle Group: Tri Axle
Sensor Locaon:
Mode:
Mode:
The strain sensors should be located on the top, center of each axle with sensor “A” being the front axle and sensor “C” the rear axle. See 218-SK
manual for more informaon on how to install the sensors.
Set the gauge to either Average (AVG) or Independent (IDP) mode. AVG
mode gives a single weight for the axle group. IDP mode measures
three separate weights for each axle on the trailer. See Spring
Suspension Gauge manual for informaon on how to set the mode.
PP-003-0059 REV C
CONTACT US!
Right Weigh, Inc.
(888) 818-2058
www.rwls.com
[email protected]
Follow Us!
Set the gauge to either Front 1 Back 2 (F1b2) or Independent (IDP)
mode. F1b2 mode measures the front axle separately from the back
axles. IDP mode will measure three separate weights for each axle on
the trailer. See Spring Suspension Gauge manual for informaon on
how to set the mode.
1 x 201-217-30 - Gauge and mounng bracket
3 x 218-SK - Weld strain sensor installaon kit
SENSOR CONFIGURATION
The gauge should be set to detect 3 Spring Sensors. See Spring Suspension
Gauge manual for more informaon on how to set the sensor configuraon.
www.rwls.com
ON/OFF
HOLD 3 SECONDS
CALIBRATE
C
HIGH
1C
LOW
234
ENTER
MENU
i
EL-003-0004
1 2 3 4 C/H C/L - KG LBS
Scan here to see addional resources on our
website including full installaon manuals,
quick set up guides, and video tutorials!
A C
BAC
B
  • Page 1 1

Right Weigh 201-EBT-30B Installation guide

201-EBT-30B
Brand
Right Weigh
Model
201-EBT-30B
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents