Right Weigh 201-EBT-20B Installation guide

Type
Installation guide
INSTALLATION OVERVIEW
201-EBT-20B
This installaon overview is not a substute for reading the product manuals
WHAT’S INCLUDED
PP-003-0054 REV C
CONTACT US!
Right Weigh, Inc.
(888) 818-2058
www.rwls.com
Follow Us!
1 x 201-217-30 - Gauge and mounng bracket
2 x 218-SK - Weld strain sensor installaon kit
SENSOR CONFIGURATION
The gauge should be set to detect 2 Spring Sensors. See Spring Suspension
Gauge manual for more informaon on how to set the sensor configuraon.
www.rwls.com
ON/OFF
HOLD 3 SECONDS
CALIBRATE
C
HIGH
1C
LOW
234
ENTER
MENU
i
EL-003-0004
1 2 3 4 C/H C/L - KG LBS
Scan here to see addional resources on our
website including full installaon manuals,
quick set up guides, and video tutorials!
A B AB
APPLICATIONS
Trailer Axle Group: Tandem Axle
Sensor Locaon:
Mode:
The gauge should be mounted and installed on the trailer and the strain sensors should be mounted on the top, center of each trailer axle with sensor
A” mounted on the front axle. See 218-SK manual for more informaon on how to install the strain sensors.
Set the gauge to Average (AVG) mode to see a single weight for the axle group. Set the gauge to Independent (IDP) mode to see separate weights for
each axle. See Spring Suspension Gauge manual for informaon on how to set the mode.
  • Page 1 1

Right Weigh 201-EBT-20B Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI