2. Right Weigh
  3. 201-EBT-20B-WB
201-EBT-20B-WB

Right Weigh 201-EBT-20B-WB Installation guide

  • Hello! I've reviewed the Installation Overview document for the Right Weigh 201-217-30 gauge and 218-SK weld strain sensor kit. This document provides details on how to install the devices correctly on a Straight Truck Walking Beam Spring Suspension system. It covers sensor location, gauge configuration and mode settings. I'm ready to answer any questions you have!
  • Where should the strain sensors be mounted?
    What mode should the gauge be set to for a single weight reading?
    How many spring sensors should the gauge be set to detect?
INSTALLATION OVERVIEW
201-EBT-20B-WB
This installaon overview is not a substute for reading the product manuals
WHAT’S INCLUDED
APPLICATIONS
Straight Truck: Walking Beam Spring Suspension (DRIVE AXLE GROUP ONLY)
Sensor Locaon:
Mode:
The strain sensors should be mounted on the back le and the front
right of the walking beam drive axle group. Make sure they are installed
on the top of the beams. See the 218-SK manual for more informaon
on how to install the strain sensors.
Set the gauge to Average (AVG) mode to see a single weight for the
drive axle group. See Spring Suspension Gauge manual for informaon
on how to set the mode.
PP-003-0056 REV C
CONTACT US!
Right Weigh, Inc.
(888) 818-2058
www.rwls.com
[email protected]
Follow Us!
1 x 201-217-30 - Gauge and mounng bracket
2 x 218-SK - Weld strain sensor installaon kit
SENSOR CONFIGURATION
The gauge should be set to detect 2 Spring Sensors. See Spring Suspension Gauge
manual for more informaon on how to set the sensor configuraon.
www.rwls.com
ON/OFF
HOLD 3 SECONDS
CALIBRATE
C
HIGH
1C
LOW
234
ENTER
MENU
i
EL-003-0004
1 2 3 4 C/H C/L - KG LBS
Scan here to see addional resources on our
website including full installaon manuals,
quick set up guides, and video tutorials!
B
A
/