2. Right Weigh
  3. 201-EBT-11B
201-EBT-11B

Right Weigh 201-EBT-11B Installation guide

  • Hello! I have reviewed the installation overview for the RWL 201-217-11 gauge and 221-SK strain sensor installation kit. This document details the included components, provides guidance on sensor configuration, and specifies the proper location for sensor installation on a straight truck with spring steer and air drive suspension. I'm ready to answer your questions about this device and the installation process.
  • Where should the strain sensor be located?
    Where should the air sensor be connected?
    What mode should the gauge be set to?
INSTALLATION OVERVIEW
201-EBT-11B
This installaon overview is not a substute for reading the product manuals
A
WHAT’S INCLUDED
APPLICATIONS
Straight Truck: Spring Steer and Air Drive Suspension
Sensor Locaon:
Mode:
The strain sensor should be located on the top, center of the steer axle.
See 221-SK manual for more informaon on how to install the sensor.
The air sensor should be connected directly to an air bag on the drive
axle group.
Set the gauge to Spring Average Air Average (SA AA) mode - separates
weight into the front axle group (steer axle) and the back axle group
(drive). See Air/Spring Suspension Gauge manual for informaon on
how to set the mode.
PP-003-0052-AU REV B
CONTACT US!
Smart Truck Soluons
+61 418 622840
rightweigh.com.au
[email protected]
Follow Us!
1 x 201-217-11 - Gauge and mounng bracket
1 x 221-SK - Epoxy strain sensor installaon kit
SENSOR CONFIGURATION
The gauge should be set to detect 1 Spring Sensor. See Air/Spring
Suspension Gauge manual for more informaon on how to set the sensor
configuraon.
www.rwls.com
ON/OFF
HOLD 3 SECONDS
CALIBRATE
C
HIGH
1C
LOW
234
ENTER
MENU
i
EL-003-0004
1 2 3 4 C/H C/L - KG LBS
Scan here to see addional resources on our
website including full installaon manuals,
quick set up guides, and video tutorials!
/