2. Home
  3. Home security & automation
  4. Security device components
  5. Digital Monitoring Products
  6. XTLplus GW

Digital Monitoring Products XTLplus GW Quick start guide

  • Hello! I've reviewed the Quick Start Guide for the DMP XTLplus-GW security panel. This document describes how to correctly setup the device, including choosing the right location for it, network connection via WPS button or keypad, and powering up. I'm ready to answer any questions you may have about the device and its initial setup.
  • Where should the XTLplus-GW be placed?
    How to connect the XTLplus-GW to a network using a WPS button?
    What if the router doesn't have a WPS button?
XTLplus-GW
Quick Start Guide
LT-1714 18252 © 2018 Digital Monitoring Products, Inc.
1SELECT A LOCATION
The XTLplus-GW is designed to be placed on a table
or other flat surface. Choose a central location in the
home to allow the panel to communicate clearly with the
system's sensors and keypads.
2CONNECT THE XTLplus-GW TO THE
NETWORK
If you are using a SecureCom Wireless Access Point
(WAP), power it up now.
If you are working with another type of router, move on to
Step 3 and then press the WPS button on the customer’s
router within 2 minutes of powering the XTLplus-GW.
If the router does not have a WPS button, move on to
Step 3 and then connect a keypad (a guide is included
with each keypad to walk you through the set-up
process). Once the keypad is set up, follow the on-screen
prompts to choose a network.
3POWER UP THE XTLplus-GW
Plug the 12VDC power supply connector into the port on
the back of the XTLplus-GW. Plug the other end of the
power supply into a dedicated wall outlet not controlled
by a switch. See Figure 1.
Figure 1: XTLplus-GW Power Connection
12VDC
Power Port
Power
Indicator LED
Dedicated
Outlet
XTLplus-GW
Quick Start Guide
LT-1714 18252 © 2018 Digital Monitoring Products, Inc.
1SELECT A LOCATION
The XTLplus-GW is designed to be placed on a table
or other flat surface. Choose a central location in the
home to allow the panel to communicate clearly with the
system's sensors and keypads.
2CONNECT THE XTLplus-GW TO THE
NETWORK
If you are using a SecureCom Wireless Access Point
(WAP), power it up now.
If you are working with another type of router, move on to
Step 3 and then press the WPS button on the customer’s
router within 2 minutes of powering the XTLplus-GW.
If the router does not have a WPS button, move on to
Step 3 and then connect a keypad (a guide is included
with each keypad to walk you through the set-up
process). Once the keypad is set up, follow the on-screen
prompts to choose a network.
3POWER UP THE XTLplus-GW
Plug the 12VDC power supply connector into the port on
the back of the XTLplus-GW. Plug the other end of the
power supply into a dedicated wall outlet not controlled
by a switch. See Figure 1.
Figure 1: XTLplus-GW Power Connection
12VDC
Power Port
Power
Indicator LED
Dedicated
Outlet
/