2. BLOTZ
  3. B28-SFC-005

BLOTZ B28-SFC-005 Assembly Instructions

  • Hello! I have reviewed the instructions for the BLOTZ 28mm Large Oval Platform B28-SFC-005. This document details how to assemble the platform, including gluing the various parts, such as the uprights, handrail, base, floor, support posts, and decorative elements. I am ready to answer any questions you might have about the assembly process or the platform itself.
  • What type of glue is needed for assembly?
    What tool is needed to remove sections from the sprue?
    What is the first assembly instruction?
28mm Large Oval Platform
B28-SFC-005
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in
place while you allow glue to dry.
Each insert section is formed from the pieces
shown above.
Glue the uprights to the handrail.
Then glue the uprights to the base plate.
Take the two “floor” pieces and six “under” pieces
from the sprue.
Glue the “under” pieces to the underside of the
“floor” pieces as shown, ensuring the notches line
up correctly.
Take the support posts.
Glue them into place within the notches.
Glue the handrail pieces in place.
Choose which set of legs to use (long or short)
Attach the base piece to the legs you have
selected.
Glue the legs into place under the platform.
Take the decorative bits.
Glue them in place on each side of the platform.
The completed platform.
/