2. BLOTZ
  3. B28-ME-108

BLOTZ B28-ME-108 Assembly Instructions

  • I have reviewed the provided instructions for the BLOTZ 28mm Short Wall - Door Desert Fort model. This document offers a step-by-step guide on assembling the laser-cut fort model using glue, and includes a door and a walkway. I am ready to assist you with any questions you have about the assembly process or the components of this model.
  • What kind of glue is required?
    Can I use sandpaper?
    What tool is needed to remove parts?
28mm Desert Fort – Short Wall - Door
B28-ME-108
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Take the pieces shown above from the sprue.
Attach the supports to the back of the wall.
Glue the assembly to the base and add the
connector pieces (see pic)
[Optional] Glue the door behind the doorway.
Add the walkway, gently aligning each lug with the
corresponding hole.
Attach the front wall.
The finished model.
/