2. BLOTZ
  3. B28-ST-121

BLOTZ B28-ST-121 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ Armillary Sphere B28-ST-121. This document outlines the assembly process for the model using glue, sandpaper, and a modelling knife, with the help of pegs or elastic bands. The build involves connecting legs to the base, assembling multiple rings, and integrating into the base. I am ready to answer your questions regarding this model's assembly process or any other questions from the instructions!
  • What type of glue is required?
    What tool is needed to remove the parts from the sprue?
    What can be used to hold pieces while glue dries?
28mm Armillary Sphere
B28-ST-121
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
A full-colour copy of these instructions can be found on our website: www.blotz.co.uk
Remove the two base and four legs from the sprue.
Glue the legs to the underside of the base.
Next remove the two large rings….
…glue them back to back…
…and insert them into the base.
Glue the middle size ring into place (at an angle of
your choice) using the lugs / holes provided.
Then glue the smaller ring into place.
/