2. BLOTZ
  3. B15-CS-006

BLOTZ B15-CS-006 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ Car Park model B15-CS-006. This document provides detailed steps for assembling the model, including instructions for the base, supports, and upper level. I'm ready to answer your questions about the assembly process and the materials needed.
  • What kind of glue is needed?
    What tool is required to remove sections from the sprue?
    What can be used to clean joints?
15mm Car Park
B15-CS-006
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the four lower wall sections and base
from the sprue.
Glue them together as shown above.
Leave to dry.
Each support is formed from the two pieces on
the left. Slot them together as shown on the
right.
Glue the supports to the underside of the upper level’s
floor.
Each end of the upper level is formed from the
pieces shown here.
Flue the short piece into place first.
Attach the ramp and small wall.
Add the outer section.
The completed upper floor.
The finished model.
/