2. BLOTZ
  3. B20-ME-100

BLOTZ B20-ME-100, B20_ME_100, BH0-ME-100 Assembly Instructions

  • I have reviewed the instructions for the Desert Fort B20-ME-100 model. This document outlines the steps for assembling the 20mm scale long wall fort, including gluing sections together and using pegs or elastic bands for drying. I'm ready to answer any questions you have about the materials, tools, or assembly process.
  • What type of glue is required?
    What tool is needed to remove parts from the sprue?
    Can sandpaper be used?
20mm Desert Fort – Long Wall
B20-ME-100
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the pieces shown above from the sprue.
Turn the “roof” upside down and attach the other
pieces to it as shown.
[Optional] Glue the door behind the doorway.
Add the front wall.
Turn the model the right way up and attack the
base, slotting each lug into the associated hole.
The finished model.
/