2. BLOTZ
  3. B28-SFC-009

BLOTZ B28-SFC-009 Assembly Instructions

  • I have reviewed the instructions for assembling the BLOTZ Large Round Platform B28-SFC-009. This document provides step-by-step guidance on how to construct the platform, including the order of assembly, the use of glue, and the various components involved. The instructions also mention the need for a modelling knife and sandpaper, and they suggest using pegs or elastic bands to hold parts while the glue dries. I'm ready to help with any questions you have about this product and its assembly.
  • What kind of glue is needed?
    What tools are required?
    What is the purpose of pegs or elastic bands?
28mm Large Round Platform
B28-SFC-009
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in
place while you allow glue to dry.
Each insert section is formed from the pieces
shown above.
Glue the uprights to the handrail.
Then glue the uprights to the base plate.
Take the four quarter pieces and two halves of the
floor.
Place the floor upside down and glue the quarter
pieces to them, making sure to align the notches.
Take the support posts.
Glue them into position as shown above.
Take the handrails.
Attach them to the support posts.
Choose which set of legs to use (long or short)
Work around the model gluing each pair of legs into
place.
The add the foot piece to each pair of legs.
Take the decorative pieces.
Glue them into position under the platform.
/