2. BLOTZ
  3. B10_MC_001

BLOTZ B10_MC_001, B10-MC-001 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ rounded building model B10-MC-001. The document provides a step-by-step guide for assembling the model using PVA glue, a modeling knife, and sandpaper, and also suggests using pegs or elastic bands. I am ready to assist with any questions you may have about the construction process.
  • What type of glue is required?
    What tool will be necessary to remove sections from the sprue?
    What can be used to clean joints?
Rounded Building #1
B10-MC-001
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue.
Please use knives with due care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the base and end pieces from the sprue.
Glue the end pieces to the base – etched detail
facing outwards.
Take the two side pieces.
Then glue them into place as shown above.
Take the roof pieces.
Starting with the three central ones, glue them into
place. Then add the rest of the roof pieces.
Take the two end frames.
Glue them into place.
The completed buildings.
/