2. BLOTZ
  3. B10-ME-206

BLOTZ B10-ME-206 Assembly Instructions

  • I have reviewed the instructions for the City Wall B10-ME-206 model. This document provides detailed steps on how to construct the 10mm Ancient City Wall Bastion, including guidance on using tools and adhesives. I'm ready to answer your questions about the assembly process or any other aspect of the model.
  • What type of glue is required?
    What tool is needed to remove pieces from the sprue?
    What can be used to clean the joints?
10mm Ancient City Wall - Bastion
B10-ME-206
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
Take the pieces shown above from the sprue.
Glue them together as shown.
Take the supports.
Glue them into position.
Add the rear wall.
Then attach the base.
Glue the walkway into position.
The side walls.
Glue them to the model as shown.
Take the front wall sections and the top strip.
Add them to the model.
/