BLOTZ B28-SFC-001 Assembly Instructions

28mm Small Round Platform

B28-SFC-001

Please read these instructions fully before starting construction.

PVA or equivalent glue will be required to stick sections together.

Sand paper can be used to gently clean any joints.

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and

remember to cut away from yourself at all times.

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in

place while you allow glue to dry.

Each insert section is formed from the pieces

shown above.

Glue the uprights to the handrail.

Then glue the uprights to the base plate.

Take the four quarter pieces.

Place them on the tabletop in a circle as shown.

Glue the floor piece to them, aligning the notches

around the edge with those underneath.

Take two of the support posts.

Glue them into place within the notches. Repeat

this with the other three pairs of support posts.

Take the four handrails.

Attach them to the support posts.

Choose which set of legs to use (long or short)

Work around the model gluing each pair of legs

into place.

The add the foot piece to each pair of legs.

Place the four insert pieces into position. These

can be swapped out to attach walkways, steps, etc