2. SDC
  3. HDB1V

SDC HDB1V User manual

  • Hello! I've analyzed the provided document for the SDC HDB1V Glass Door Mounting Kit installation. The document gives detailed step-by-step instructions on how to install the mounting bracket and armature plate, including proper setup for different glass door thicknesses(3/8", 1/2", and 5/8"). It emphasizes correct alignment of the components and use of the provided lock template for accurate drilling. I am ready to answer any questions you have about it.
  • What is included in the kit?
    How do I install the kit on 3/8" or 1/2" glass doors?
    How do I install the kit on 5/8" glass doors?
    What should I do after installing the bracket?
BRACKET
BAR
STEP 1
INSTALL BRACKET AND BAR TO
GLASS DOOR
STEP 2
SET SCREW
SECURE SET SCREWS WITH THE
PROVIDED ALLEN WRENCH
RUBBER PADS
(2x)
11 GA. SHIM
(2x)
FOR 3/8” & 1/2" GLASS
DOORS: PLACE RUBBER PAD
& 11 GA. SHIMS ON BOTH
SIDES. PLACE 18 GA. SHIM
ON SET SCREW SIDE.
FOR 5/8” GLASS DOORS:
PLACE RUBBER PAD ON
BOTH SIDES (1) 11GA. SHIM &
(1) 18 GA. SHIM ON EACH
SIDES OF BRACKET.
INSTALL ARMATURE PLATE TO
BRACKET
STEP 4
FRAME HEADER
SIDE VIEW
GLASS DOOR CLOSED POSITION
STEP 5
ADJUST BAR (SEE STEP 1)
ADJUST ARMATURE PLATE
AS NEEDED FOR PROPER
ALIGNMENT BETWEEN
ARMATURE PLATE AND
EMLOCK SURFACE.
GLASS DOOR
18 GA. SHIM
(1x)
PLACE DOOR IN CLOSED
POSITION, FOLD TEMPLATE AS
INDICATED BY DOTTED LINE AND PLACE
TEMPLATE AGAINST FRAME HEADER AND
BRACKET THEN MARK AND DRILL AS INDICATED.
STEP 3
LOCK TEMPLATE
(PACKAGED w/LOCK)
FRAME HEADER
SIDE VIEW
GLASS DOOR CLOSED POSITION
RUBBER PADS
(2x)
SHIMS
(1) 18 GA.
(1) 11 GA.
SECURITY DOOR CONTROLS ■ WWW.SDCSECURITY.COM
[t] 800.413.8783 ■ 805.494.0622 ■ E-mail: [email protected] ■ 801 Avenida Acaso, Camarillo, CA 93012 ■ PO Box 3670, Camarillo, CA 93011
INSTALLATION INSTRUCTIONS
HDB1V
GLASS DOOR MOUNTING KIT
P:\INST INSTRUCTIONS\EMLOCKS\INST-HDB1V Rev D 04-22 Page 1
Any suggestions or comments to this instruction or
product are welcome. Please contact us through
our website or email engineer@sdcsecurity.com
SHIM
(1) 11 GA.
* For 5/8" Glass doors remove (1) 11 GA. shim
*
BAR
/