2. SDC
  3. 6100ED RIM
6100ED RIM

SDC 6100ED RIM User manual

  • Hello! I have reviewed the installation instructions for the SDC REX Switch Kit 6100ED RIM. This document provides crucial information on installing the REX switch, including assembly, wiring, and alignment of the push pad. I am ready to answer your questions about the installation process and features of this product.
  • What should be removed before installing the REX switch?
    How is the REX Switch Assembly installed?
    What is the wiring configuration for the switch?
INSTALLATION INSTRUCTIONS
P:\INST-INSTRUCTIONS\ELR KITS\INST-LRY6KR REV - 08-22 Page 1
Any suggestions or comments to this instruction or
product are welcome. Please contact us through
our website or email eng[email protected]om
LRY61R
YALE REX SWITCH KIT
MODEL: 6100ED RIM
SECURITY DOOR CONTROLS ■ WWW.SDCSECURITY.COM
[t] 800.413.8783 ■ 805.494.0622 ■ E-mail: [email protected] ■ 801 Avenida Acaso, Camarillo, CA 93012 ■ PO Box 3670, Camarillo, CA 93011
Remove Cover and Dogging from device if present.
Slide REX Switch Assembly into Rail. Position the bracket so that the Switch is aligned under the Push Pad when the
Push Pad is depressed. Once in position, tighten two set screws to secure in place.
Switch Wiring Detail
WHITE – COM
ORANGE – N/C
YELLOW – N/O
REX Switch
Assembly
Tighten 2x set
screws to secure.
Cover
Rail
SwitchPush Pad
/