2. SDC
  3. LRDX1R

SDC LRDX1R User manual

  • Hello! I've reviewed the installation instructions for the SDC REX Switch Kit LRDX1R. This document outlines the step-by-step process for mounting the switch kit which includes removing the end cap, end cap bracket, cover and then sliding the REX bracket assembly. It also covers the wiring specifications. I'm ready to answer any questions you have about the installation process or the device.
  • What are the wiring specifications?
    What should I do after sliding the REX bracket assembly in place?
    What is the next step after installing the bracket?
P:\INST INSTRUCTIONS\ELR KITS\INST-LRDX1R REV A 07-22 Page 1
Any suggestions or comments to this instruction or
product are welcome. Please contact us through
our website or email engineer@sdcsecurity.com
Remove the End Cap, End Cap bracket and Cover. Slide the REX bracket assembly into the device and under the push
bar mounting plate so the mounting hole aligns with existing tapped hole in the Push Bar base. Insert the supplied
screw & washer and tighten the screw to lock the bracket in place. Replace Cover, End Cap bracket and End Cap.
Wiring Specification
COM = WHT
N/O = RED
N/C = GRN
3A @ 125VAC
RESISTIVE
LRDX1R
DETEX REX SWITCH KIT
MODELS: 10, 20, 40, 50, 60 & 80 SERIES
Cover
End Cap
bracket
End Cap
Washer & Screw
(supplied)
SECURITY DOOR CONTROLS ■ WWW.SDCSECURITY.COM
[t] 800.413.8783 ■ 805.494.0622 ■ E-mail: [email protected] ■ 801 Avenida Acaso, Camarillo, CA 93012 ■ PO Box 3670, Camarillo, CA 93011
INSTALLATION INSTRUCTIONS
/