28mm Small Round Platform
B28-SFC-001
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in
place while you allow glue to dry.
Each insert section is formed from the pieces
shown above.
Glue the uprights to the handrail.
Then glue the uprights to the base plate.
Take the four quarter pieces.
Place them on the tabletop in a circle as shown.
Glue the floor piece to them, aligning the notches
around the edge with those underneath.
Take two of the support posts.
Glue them into place within the notches. Repeat
this with the other three pairs of support posts.
Take the four handrails.
Attach them to the support posts.
Choose which set of legs to use (long or short)
Work around the model gluing each pair of legs
into place.
The add the foot piece to each pair of legs.
Place the four insert pieces into position. These
can be swapped out to attach walkways, steps, etc
/
