Japanese Gateway
B28-WF-117
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Take the base, four wall sections, uprights and cross-
pieces from the sprue.
Glue the walls back to back and attach to the base
so that there is a 2mm gap at either end (see pic).
Glue two uprights and cross-piece together as shown.
Glue these to the wall so the uprights are flush with
the walls.
Glue the triangular supports in place.
Take each pair of central supports and glue them
back-to-back as shown on the right, ensuring the
notches align.
Glue the hinge to each support.
Attach the crossbeams to this central support.
Add the other central support and ridge.
NOTE: Ensure the lugs are on the OUTSIDE edge of the
assembly as shown in the picture.
Take the doors, handles and locking bar from the
sprue.
Attach the handle to each door.
Before going any further it is easiest if you paint the
components now.
Painting
The walls were sprayed white using car undercoat
The roof was sprayed red using car undercoat then a
light black ink wash applied.
The stone was sprayed grey using car undercoat
then a light black in wash applied.
The central assembly and doors were left as plain
wood.
The walls with their stonework and roof sections. Glue the central section into place (with the doors)
then add the stonework and roof sections.
Finally add the roof sections.
The finished gateway with basing material added.
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
BLOTZ B10_ME_001 Assembly Instructions
-
BLOTZ B15-ME-110 Assembly Instructions
-
BLOTZ B28-WF-116 Assembly Instructions
-
BLOTZ BH0-ME-110 Assembly Instructions
-
BLOTZ B28-ME-216 Assembly Instructions
-
BLOTZ B28-SFW-007 Assembly Instructions
-
BLOTZ B28-ME-005 Assembly Instructions
-
BLOTZ B28-ME-106 Assembly Instructions
-
BLOTZ B20-WF-117 Assembly Instructions
-
BLOTZ B15-ME-208 Assembly Instructions
