2. Workrite Ergonomics
  3. Banana Board

Workrite Ergonomics Banana Board Installation guide

  • Hello! I've reviewed the Assembly & Installation Instructions for the Workrite Banana-Board keyboard platforms, models UB2180S25 and UB2181SN. This guide provides detailed steps on how to mount the keyboard platform to an adjustable arm using keps nuts and includes information for routing cords using provided clips. I'm ready to assist you with any questions you might have about this product and its installation process.
  • What tools are needed for assembly?
    How many keps nuts are required?
    How many cord clips are included?
1 of 2 Workrite Ergonomics | (800) 959–9675 www.workriteergo.com
A Banana-Board Keyboard Platform
Qty: 1 B ⅜" #10-32 Keps Nuts
Qty: 4 C Cord Clips
Qty: 2
Hardware Kit #AKP-HDWR-BB
Required:
Socket wrench with ⅜" socket
Adjustable Keyboard Arm
Mount Keyboard Platform to Arm
1.1 Align the threaded studs on the bottom of the Banana-Board (A) with the mounting holes in the keyboard arm.
1.2 Attach with four ⅜" #10-32 Keps Nuts(B) and tighten securely.
Note: Mount your adjustable keyboard arm to your worksurface using the instructions that came with your
adjustable keyboard arm.
UB2180S25 UB2181SN
Assembly & Installation Instructions:
Banana-Board Platform Mounting
Parts Included
Tools Required:
A
B
1
Keyboard arm
Keyboard track
1.2
1.1
2 of 2 Workrite Ergonomics | (800) 959–9675 www.workriteergo.com
1500047 Rev C
Attach Cord Clips and Rout Cords on Arm & Under Worksurface
Note: Make sure your keyboard arm is fully extended
before routing your cables.
Place one Cord Clip (C) on the side of the arm mechanism.
Place the other Cord Clip on the rear of the track. Do the
opposite side in the same fashion if cords run down the
le side.
Caution: Adhesion is designed
to bond immediately. You will
not be able to reposition the
clip once it's in place.
2
C
C
Under Worksurface
Arm fully extended
Cables will be out
of the way when
platform is in use
/