Workrite Ergonomics Banana Board User guide

Type
User guide
1 of 2 Workrite Ergonomics | (800) 959–9675 www.workriteergo.com
A Banana-Board Keyboard Platform
Qty: 1 B ⅜" #10-32 Keps Nuts
Qty: 4 C Cord Clips
Qty: 2
Hardware Kit #AKP-HDWR-BB
Required:
Socket wrench with ⅜" socket
Adjustable Keyboard Arm
Mount Keyboard Platform to Arm
1.1 Align the threaded studs on the bottom of the Banana-Board (A) with the mounting holes in the keyboard arm.
1.2 Attach with four ⅜" #10-32 Keps Nuts(B) and tighten securely.
Note: Mount your adjustable keyboard arm to your worksurface using the instructions that came with your
adjustable keyboard arm.
UB2180S25
Assembly & Installation Instructions/User Guide:
Banana-Board Platform Mounting
Parts Included
Tools Required:
A
B
1
Keyboard arm
Keyboard track
1.2
1.1
2 of 2 Workrite Ergonomics | (800) 959–9675 www.workriteergo.com
1500289 Rev B
Attach Cord Clips and Route Cords on Arm & Under Worksurface
Note: Make sure your keyboard arm is fully extended
before routing your cables.
Place one Cord Clip (C) on the side of the arm mechanism.
Place the other Cord Clip on the rear of the track. Do the
opposite side in the same fashion if cords run down the
le side.
Caution: Adhesion is designed
to bond immediately. You will
not be able to reposition the
clip once it's in place.
Right to Le Handedness
The Banana-Board Platforms feature a patented mousing platform
that slides easily from side to side to accommodate both le
handed and right handed users.
Document Holder
The Banana-Board Platforms feature a convenient document holder.
Just insert your document into the slot in the back of the platform.
3
4
2
C
C
Under Worksurface
Arm fully extended
Cables will be out
of the way when
platform is in use
  • Page 1 1
  • Page 2 2

Workrite Ergonomics Banana Board User guide

Type
User guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI