2. Right Weigh
  3. 201-EBT-22B
201-EBT-22B

Right Weigh 201-EBT-22B Installation guide

  • Hello! I've reviewed the installation overview for Right Weigh's gauge and sensor kits including models 201-217-32, 221-SK, 201-SK, and 101-SK. This document details how to install the sensors and configure the gauge for different axle setups. I am ready to assist you with any questions you have about the installation process or the features of these products.
  • What does the gauge measure?
    Where should the strain sensors be located?
    How should the air sensors be connected?
    What is the Spring Average Air Average (SA AA) mode?
    What is the Spring Average, Air Independent (SA Ai) mode?
INSTALLATION OVERVIEW
201-EBT-22B
This installaon overview is not a substute for reading the product manuals
WHAT’S INCLUDED
APPLICATIONS
Straight Truck: Dual Spring Steer and Dual HCV Air Drive
Axle Groups
Sensor Locaon: Sensor Locaon:
Mode:
Mode:
The strain sensors should be located on the top, center of each steer
axle with sensor “A” being the front axle. See 221-SK manual for more
informaon on how to install the sensors. The air sensors should be
connected directly to an air bag on each side of the drive axle group.
See 201-SK and 101-SK installaon manuals for more informaon on
how to install the air line connecons.
The strain sensors should be located on the top, center of each steer
axle with sensor “A” being the front axle. See 221-SK manual for more
informaon on how to install the sensor. Air sensor A should be
connected directly to an air bag on the li axle and air sensor B should
be connected directly to an air bag on the drive axle group. See
201-SK and 101-SK installaon manuals for more informaon on how
to install the air line connecons.
Set the gauge to Spring Average Air Average (SA AA) mode - separates
weight into front axle group (steer) and back axle group (drive). See
Air/Spring Suspension Gauge manual for informaon on how to set the
mode.
PP-003-0058 REV C
Dual Spring Steer, Air Li Axle, and Air Drive Axle Groups
CONTACT US!
Right Weigh, Inc.
(888) 818-2058
www.rwls.com
[email protected]
Follow Us!
Set the gauge to Spring Average, Air Independent (SA Ai) mode -
separates weight into front axle group(steer), and two independent
air axle groups (li axle and drive axle groups). See Air/Spring
Suspension Gauge manual for informaon on how to set the mode.
1 x 201-217-32 - Gauge and mounng bracket
2 x 221-SK - Epoxy strain sensor installaon kit
SENSOR CONFIGURATION
The gauge should be set to detect 2 Spring Sensors. See Spring
Suspension Gauge manual for more informaon on how to set the sensor
configuraon.
www.rwls.com
ON/OFF
HOLD 3 SECONDS
CALIBRATE
C
HIGH
1C
LOW
234
ENTER
MENU
i
EL-003-0004
1 2 3 4 C/H C/L - KG LBS
Scan here to see addional resources on our
website including full installaon manuals,
quick set up guides, and video tutorials!
1 x 201-SK - Air line and electrical installaon kit
1 x 101-SK - Air line installaon kit
BA
BA
/