2. BLOTZ
  3. B28-STA-152

BLOTZ B28-STA-152 Assembly Instructions

  • I've reviewed the instructions for the Star Ship T-Junction B28-STA-152 model. The document details the assembly process, emphasizing the need for PVA glue, sandpaper, and a modeling knife. It guides the user through each stage, from removing parts from the sprue to attaching decorative elements. I'm ready to assist you with any questions you might have about this model's assembly.
  • What type of glue is required for assembly?
    What tools are needed?
    What is the purpose of pegs or elastic bands?
28mm Star Ship T-Junction (Narrow)
B28-STA-152
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the supports and long wall pieces from
the sprue.
Glue them together as shown above.
Then take the long decorative strips.
Attach these into place as shown.
Each corner support is formed from the two
pieces on the left. Glue them together as shown
on the right.
Take the pieces shown above.
Attach them to the corner post.
Take the decorative pieces.
Attach them to the corner post as shown.
Two corner posts and one long wall.
Using the lugs/holes to locate the correct
positions, attach the corner posts and long wall to
the base.
The finished model.
/