Coats 9010 Mod Kit Operating instructions

Brand: Coats

Model: 9010 Mod Kit

Type: Operating instructions

These are instructions for replacing the clamp covers on a 9010

to increase the outside rim clamping to include a 22-inch rim.

Tools required: 8mm Ball End Allen Wrench

Red Loctite

Miscellaneous Tools, Hammer, Handle for Allen

Wrench, Wire Brush

1. Clean off table top with wire brush and remove any plastic

booties from clamps.

2. Cycle clamps to their outward position.

3. Remove air pressure supply and bleed system to zero

pressure.

4. Rotate table until one clamp is toward the front.

5. Remove the inﬂate hose from the clamp and lay aside.

6. Remove any dirt from in the screw socket. Using the 8mm

ball end allen wrench with an extension, remove the clamp from

the slide and discard the screw (Figure 1).

7. Remove the clamp slide cover from the carrier and discard.

(Figure 2)

8. Position a new slide cover over the slide carrier (Figure 3).

9. Install a ﬂat head screw (supplied) through the slide cover

into the clamp.

10. Use a small amount of red loctite on the screw and

tighten 18-20 ft. pounds with the 8mm allen wrench.

11. Position the clamp at the outboard hole on the slide and

use the new shorter socket head screw with a small amount of

red loctite (Figure 4).

12. Tighten the screw 30-40 ft. pounds with the ball end

8mm allen wrench.

13. Reinstall the air ﬂate hose.

14. Rotate the table for the next clamp assembly and repeat

the steps.

15. When all clamp covers have been replaced, reconnect

the air supply to the machine.

16. First, listen for any leaks and cycle machine several

times. After allowing Red Loctite to dry per manufacturer’s

recommendations, change a tire on the machine to assure a

quality job.

9010 Mod Kit

To increase outside clamping for a 22-inch rim.

COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565

(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.ammcoats.com

Figure 1

Figure 2

Figure 4

Figure 3

Coats 9010 Mod Kit Operating instructions

Coats 9010 Mod Kit Operating instructions

Coats 9010 Mod Kit Operating instructions

Related papers

Other documents