Coats Kit 85009953, 28 Extended X-Clamps Operating instructions

Coats
Brand
Coats
Model
Kit 85009953, 28 Extended X-Clamps
Category
Motor vehicle accessories & components
Type
Operating instructions
85009954 00 07/08 © COPYRIGHT 2008 HENNESSY INDUSTRIES AND COATS ALL RIGHTS RESERVED PRINTED IN U.S.A.
28" Extended X-Clamps Kit #85009953
for Outside Clamping on Rim Clamp Tire Changers
(28” - 20", Outboard Position or 23" -18", Inboard Position)
COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565
(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.ammcoats.com
Installation
1. Unpack components.
2. Clean any debris from existing clamps, clamp carrier, and slides to
make replacement easier.
3. Remove the existing clamps by (refer to figure 1):
A. Depressing the large end of the spring loaded position button
with a finger through the large access hole on the side of the
clamp. At the same time depress the opposite end of the pin with
a small tool such as a valve core tool or small screwdriver through
the small access hole on the opposite side of the clamp.
B. Slide the clamp off the clamp carrier.
4. Clean and lubricate the clamp carriers and slides as instructed in
the maintenance section of the machine’s Operator Manual.
5. Install an Extended X-Clamp as follows (refer to figure 2):
A. Be sure the clamp is properly oriented on the table top—open
side of clamp jaw “V” toward center of table top.
B. Be sure the spring loaded position button is properly oriented in
the clamp carrier. If not, the clamp will be loose after installation.
C. Compress both sides of the spring loaded position pin and slide
the clamp onto the carrier and over the pin until it locks into posi-
tion.
6. Repeat step 5 for the remaining Extended X-Clamps.
7. Be sure all four Extended X-Clamps are in the same position
before attempting to secure a tire-wheel assembly.
Note: With clamp in outboard position the range is 28" - 20" or with
the clamp in inboard position range is 23" -18".
Usage
1. Depress the spring loaded position button with a finger, through
the large access hole in the side of the clamp. Slide the clamp to the
desired position for the wheel diameter about to be secured.
2. Be sure all four Extended X-Clamps are in the same position
before attempting to secure a tire-wheel assembly.
Note: With clamp in outboard position the range is 28" - 20" or with
the clamp in inboard position range is 23" - 18".
Figure 1 - Remove Existing Clamps.
Figure 2 - Install Extented X-Clamps.
Parts Identification
Qty. Part No. Description
4 85009931 28" Grip Max Clamp
8 8182682 10-24 Nylock Nut
8 8301805 #10 Flat Washer
8 85000594 UHMW Grip
8 85000595 Laminated Clamp Cover
8 85000610 1/4 x 1-1/4 Shoulder Screw
4 8182250 Spring & Housing Assy Plunger
  • Page 1 1

Coats Kit 85009953, 28 Extended X-Clamps Operating instructions

Coats
Brand
Coats
Model
Kit 85009953, 28 Extended X-Clamps
Category
Motor vehicle accessories & components
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents