Coats Kit 8185531, Clamp Extension/Reduction Operating instructions

Type
Operating instructions
8185589 00 10/05 1 of 2 © COPYRIGHT 2005 HENNESSY INDUSTRIES AND COATS ALL RIGHTS RESERVED PRINTED IN U.S.A.
44--iinncchh CCllaammpp EExxtteennssiioonn oorr
22--iinncchh CCllaammpp RReedduuccttiioonn
KKiitt ##88118855553311
FFoorr UUssee WWiitthh CCooaattss
MMooddeell 99002244 TTiirree CChhaannggeerr
COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565
(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.Hennessy-Ind.com
Make sure that the support is well
positioned, as shown. Introduce pin
A into hole B.
Secure the pin by the rubber fas-
tening cable. Repeat the same pro-
cedure for the other clamps.
Set the extension on the clamp,
as shown.
Extension Instructions
Reduction Instructions
Use an 8mm hexagonal wrench to
loosen the clamp screw.
Turn the clamp by 180 degrees. Use the 8mm hexagonal wrench
to tighten the screw.
Turn the whole clamp support on
the turntable by 180 degrees.
Set the support on the clamp.
Set the pin and lock it by the rub-
ber fastening cable.
Repeat the same procedure for
the other clamps.
8185589 00 10/05 2 of 2 © COPYRIGHT 2005 HENNESSY INDUSTRIES AND COATS ALL RIGHTS RESERVED PRINTED IN U.S.A.
  • Page 1 1
  • Page 2 2

Coats Kit 8185531, Clamp Extension/Reduction Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI