5 7/8"
10 5/8"
6"
10 1/2"
7 1/8"
13 1/8"
5/8"
1/4"
GMQ
Make the following modifi cations to your pole mount ends to allow the attachment of your new
Bungee Clamps.
Use a 1/4” drill bit to drill the holes. You may want to drill the holes partially through from each side
to prevent the wood from splintering on the back side when the drill bit pushes through.
The slots can easily be created with a hand saw.
You may adjust the tension on your bungee clamps by tying a knot on the end of the bungee cord.
This method of adjustment doesn’t require the slots to be cut, but the holes are still required.
Note: The bungee clamps should be positioned in-line with the fabric
Bungee Clamp Installation Instructions
Bungee Clamp
Attachment
/
1/4
Cut lots with hand
saw, no wider than 1/
Close Up View of Drilled Hole, and Cut Slot
Z44
18"
11 1/4"
5/8"
1/4"
A34
4"
10"
5/8"
1/4"
1"
1/2"
1/4"
1"
1/2"
1/4"
Little Gracie
/
