USE OF THE SELECTION CONTROLS
C
. SPIN SPEED SELECTOR KNOB
To select the final spin speed, turn this control until the selector
mark (L) coincides with the desired rpm.
This knob selects the final spin speed. To select a speed,
press down and turn until the desired speed coincides with
the selector mark.
The final spin cycle reaches the maximum speed selected in
non-delicate programmes. The middle and final spin cycles
for mixed, synthetics and delicate programmes is carried out
at 400 r.p.m.
If you do not want a spin cycle, coincide the spin exclusion
symbol with the selector mark (L).
THE KNOB CAN BE TURNED IN BOTH DIRECTIONS.
D
. SUPER-RINSE BUTTON
Pressing this button removes the last vestiges of soap powder from the
fabrics, as the rinses are done with more water. Programmes 1-2-3-4.
E
. INTENSIVE WASH BUTTON
Use the intensive wash button for cotton programmes (1-2-3-4).
When the button is pressed, the selected temperature is kept constant during
all the phases of the wash cycle.
This feature combined with a sustained mechanical action results in excellent
washing results with resistant and particularly dirty fabrics.
F
. ANTI-CREASING BUTTON
This button works in all programmes except the 29-minute cycle.
It can be used to minimise wrinkling of fabrics during wash programmes.
The results obtained differ with each programme:
In programmes for NORMAL FABRICS, pressing this button will cause the
machine to stop on the last rinse, leaving clothes soaking in water.
To complete the programme and spin the clothes, press the button again to
release it.
In programmes for SYNTHETIC FABRICS, pressing this button will cut out
the intermediate spins and perform only one final spin at low sped, thus
minimising the stress suffered by fabrics.
In programmes for HIGHLY DELICATE FABRICS, pressing this button will
cause the machine to stop on the last rinse, leaving clothes soaking in water.
To complete the programme and spin the clothes, press the button again to
release it.
Do not press this button if the “vigorous spin” (normal fabrics)
programme is selected.
G
. ON/OFF PILOT LIGHT
H
. ON/OFF BUTTON
USE OF THE SELECTION CONTROLS
A
. PROGRAMME SELECTOR KNOB
To select the desired wash programme, turn this control until
the selector mark (L) coincides with the programme number
or symbol.
ALWAYS ROTATE the control in a clockwise direction, never
in an anticlockwise direction. Do not press the “on” button
(H) before selecting the programme
.
If you wish to modify the position of the control or select
another programme once a cycle has commenced, press
the Start/Stop key. Press again to recommence once the
modification has been completed.
f
. PROGRAMME STAGE DISPLAY
This displays the current programme stage throughout the programme selected.
WASH: STOP WITH WATER IN DRUM:
RINSE: END OF PROGRAMME:
FINAL SPIN:
t
. TIME REMAINING DISPLAY
This displays the Approx. time remaining in minutes to the end of the
programme.
Programme duration is given AS A GUIDELINE ONLY. This time may vary either way depending
on the temperature selected, the amount and type of clothes and the installation conditions
(water temperature, ambient temperature, mains water pressure, etc.)
B
. TEMPERATURE SELECTOR KNOB
To select the desired wash temperature, turn this control until
the selector mark (L) coincides with the desired temperature.
If you wish to carry out a cold wash, turn the knob until the
cold symbol coincides with the selector mark (L).
THE KNOB CAN BE TURNED IN BOTH DIRECTIONS.
Do not exceed the maximum temperature recommended for
each cycle in the table of programmes.
35
36
PROGRAMAS
TEMPERATURA
CENTRIFUGADO
ANTI
ARRUGAS
SUPER
ACLARADO
LAVADO
INTENSIVO
MARCHA
PARADA