11
USING THE SELECTORS
A
. PROGRAMME / TEMPERATURE SELECTOR
To select the desired washing programme/temperature, turn
this selector until the number or symbol for the programme
desired is opposite the guide mark (p). Temperature selection
depends on the programme selected.
To modify settings or change programmes once the
programme has started, proceed as follows:
- Hold down Start/ Pause until the Stop indicator on the Time
Remaining display lights up.
- Release the button. After a few seconds the lamp on the display will go out.
- Select the desired programme.
- Hold down Start/Pause again until one of the lamps on the display lights up.
- The machine will then run through the new programme selected.
To add more clothes during a programme, proceed as follows:
- Hold down Start/ Pause until one of the Time Remaining display indicators blinks.
-Wait until the Door Secure indicator goes out, open the door and add more clothes to the
wash.
- Close the drum door and the outer cover tight.
- Press Start/Pause.
THIS CONTROL CAN BE TURNED BOTH WAYS.
V
. TIME REMAINING TO END OF CYCLE
This displays the Approx. time remaining in minutes to the
end of the programme.
Programme duration is given AS A GUIDELINE ONLY. This
time may vary either way depending on the temperature
selected, the amount and type of clothes and the installa-
tion conditions water temperature, ambient temperature,
mains water pressure, etc.).
B.
SPIN SELECTOR
To select the spin speed, turn the selector until the mark for
the desired rpm is opposite the guide mark (p).
The final spin for resistant fabrics (indicated as COTTON)
will be at the selected speed.
In programmes for synthetic fabrics (SYNTHETICS)
intermediate spins are at 400 rpm, and the final spin is at
800 rpm.
In the DELICATES programme there are no intermediate spins, and the final spin is at 400
rpm.
In the WOOL programmes (30º and Cold Wash) there are no intermediate spins, ant the
final spin is at 800 rpm.
For specific programmes:
The 29´/44´programme runs one intermediate spin at 400 rpm and a final spin at 800
rpm.
In the program HAND WASH there is no spin-dry during the washing phases and the
final spin-dry is done at 800 rpm.
To cut out spinning altogether, match the No Spin symbol to the guide mark.
THIS CONTROL CAN BE TURNED BOTH WAYS.
p
p