23
USE OF THE SELECTION CONTROLS
A
. PROGRAMME SELECTOR KNOB
This control allows you to select the washing programmes.
ALWAYS ROTATE the control in a clockwise direction,
never in an anticlockwise direction. Do not press the “on”
button (H) before selecting the programme
.
If you wish to modify the position of the control or select
another programme once a cycle has commenced, press
the ON/OFF button. Press again to recommence once the
modification has been completed.
B
. TEMPERATURE SELECTOR KNOB
This control allows you to select the temperature of your
wash.
If you wish to carry out a cold wash, turn the knob until the
cold symbol coincides with the selector mark.
THE KNOB CAN BE TURNED IN BOTH DIRECTIONS.
Do not exceed the maximum temperature recommended
for each cycle in the table of programmes.
D
. ANTI-CREASING BUTTON
This button works in all programmes except the «32-minute cycle».
When it is pressed, the machine stops on the last rinse, leaving the clothes
soaking in a full drum of water.
To complete the programme and spin the clothes, press the button again to
release it.
DO NOT PRESS THIS BUTTON IF THE «VIGOROUS SPIN»
(COTTON) PROGRAMME IS SELECTED.
E
. SPIN VARIATION BUTTON 850/400
When this button is pressed, the spin after the last rinse will be at 400 r.p.m.
instead of 850 r.p.m.
N.B.: The spin in programmes for mixed, synthetic and delicate fabrics is
always at 400 r.p.m.
G
. ON/OFF PILOT LIGHT
H
. ON/OFF BUTTON
MOD. ITL 856 T