Otsein-Hoover LB LTD1084 H User manual

Otsein-Hoover
Brand
Otsein-Hoover
Model
LB LTD1084 H
Category
Washing machines
Type
User manual

This manual is also suitable for

31
EN
When contacting a OTSEIN/HOOVER or one of its Technical
Assistance Centre always refer to the model (see control panel) and
the registration and series numbers which are indicated at the bottom
of the machine under the lower panel or on the warranty certificate.
That is to say, everything that appears in the box.
Providing this information will ensure a faster and more efficient service.
INTRODUCTION
Read this manual carefully as it offers practical advice to help you get the most from your
washing machine.
This Instruction Manual
contains everything you need to
know about the everyday
running of your machine. Keep
it for future reference.
An Installation and
Maintenance Manual is also
provided which you should
consult during the installation
and routine maintenance of
your washing machine. The ma-
nual also contains information
about possible working
problems, advice about the
wash load, an explanation of
label symbols and hints about
how to remove stubborn stains.
1.- CONTROL PANEL
2.- LID
3.- DRUM
4.- DETERGENT COMPARTMENT
5.- FILTER DOOR
6.- FILTER
7.- WHEEL TROLLEY (Depending on model)
32
INDEX
GUARANTEE..............................................................................
33
TECHNICAL DATA .......................................................................
34
OPENING THE LID – LOADING ................................................
35
DETERGENT DISPENSER ........................................................
36
VARIABLE CAPACITY .................................................................
37
PROGRAMME SELECTION .......................................................
37
CONTROL DESCRIPTION ..........................................................
38
TABLE OF PROGRAMMES .......................................................
42
page
33
SERVICE
B
A
GUARANTEE
1.
The appliance comes with a guarantee certificate.
2.
Complete part B and keep it in a safe place. It should
be presented to the Technical Assistance Centre in
the event of a repair being necessary along with the
legal receipt issued by the dealer on purchase.
3.
Do not forget to send part A of the Guarantee
Certificate to be validated within 15 days of purchase.
34
TECHNICAL DATA
Load capacity ................................................................
kg.
Voltage .............................................................................
V.
Wash motor power rating ................................................
W.
Spin motor power rating ..................................................
W.
Electropump power rating ...............................................
W.
Heating element power rating .........................................
W.
Max. power input .............................................................
W.
Fuse ................................................................................
A.
Water pressure ...........................................................
MPa
Spin speed ......................................................
r.p.m./min
Water consumption (60º C programme) ........................
lit.
Energy consumption (60º C programme) ..................
kWh
Energy efficiency rating .......................................................
4,5
230
175
340
30
1.950
2.200
10
0,05 min.
0,8 max.
1000
54
0,85
A
1000
R.P.M.
4,5
230
175
300
30
1.950
2.200
10
0,05 min.
0,8 max.
800
54
1,03
B
800
R.P.M.
35
OPENING THE DRUM
1.
Lift the lid (A) and open completely. Next open the drum
door following these instructions:
2.
Press catch (B) and kept it pressed down.
Press the first shutter (C) to unlock the two shutters (C)
and (D).
3.
Open the second shutter (D). Open the first shutter (C).
Place the washing in the drum.
4.
Close the first shutter (C).
Close the second shutter (D) so that the catch on the
first shutter fits correctly into the slot. Release.
5.
Ensure that both shutters are perfectly aligned and properly
closed.
IMPORTANT: IT IS IMPORTANT TO MAKE SURE THAT
THE DRUM IS CAREFULLY CLOSED BEFORE
OPERATING THE MACHINE, OTHERWISE THE
MACHINE OR LAUNDRY COULD GET DAMAGED.
2 min.
IMPORTANT: A SPECIAL
SAFETY DEVICE PREVENTS
THE LID FROM BEING
OPENED IMMEDIATELY
AFTER THE WASH HAS
FINISHED. ONCE THE SPIN
CYCLE HAS FINISHED, WAIT
FOR 2 MINUTES BEFORE
TRYING TO OPEN THE LID.
A
FRONT OF THE
WASHING MACHINE
C
B
D
WASHING MACHINE
LID
FRONT OF THE
WASHING MACHINE
D
C
FRONT OF THE
WASHING MACHINE
D
C
FRONT OF THE
WASHING MACHINE
C
D
36
I
II
MAX.
MAX.
MAX.
DETERGENT DISPENSER
The detergent dispenser is divided into 4 compartments:
• Compartment I, is for prewash powder detergent. The recommended quantity is
60 gm of detergent (for 4,5 kg of laundry).
• Compartment II, is for wash powder detergent. The recommended quantity is 120
gm of detergent (for 4,5 kg of laundry).
• The compartment is for bleach. The recommended quantity is 7 cl.
• The compartment is for fabric conditioners, scenting agents and special
additives. The recommended quantity is 5 cl.
The detergent compartment has two guidance lines:
• RECOMMENDED (lower line). This indicates the recommended level for the prewash
and wash compartments.
• MAX. This indicates the maximum level which should never be exceeded.
MAXIMUM
(wash)
MAXIMUM
(bleach and scenting agent)
MAXIMUM
(prewash)
RECOMMENDED
37
VARIABLE CAPACITY
This washing machine automatically adapts the water level to the type and quantity of clothes
to be washed. So it is possible to obtain a «customised» wash, even in terms of energy. This
system reduces water and energy consumption and provides an appreciable reduction in
wash time.
PROGRAMME SELECTION
WHEN SELECTING A PROGRAMME, ENSURE THAT THE START/STOP BUTTON IS
NOT ACTIVATED.
To select a programme:
• Programmes are selected by means of the corresponding control knob (A). See the
table of programmes.
• Select the wash temperature by means of the corresponding control knob.
If your model offers this function:
• Select the spin speed by means of the corresponding control knob.
• Select the different options available by pressing the corresponding buttons.
38
CONTROL DESCRIPTION
PROGRAMME SELECTOR KNOB ............................................
- PROGRAMME STAGE DISPLAY ..................................
- TIME REMAINING DISPLAY .........................................
TEMPERATURE SELECTOR KNOB..........................................
SPIN SPEED SELECTOR KNOB ...............................................
BUTTONS ...................................................................................
ON/OFF PILOT LIGHT ...............................................................
ON/OFF BUTTON.......................................................................
SELECTOR MARK .....................................................................
A
f
t
B
C*
D*
G
H
L
39
USE OF THE SELECTION CONTROLS
THE FOLLOWING TABLE SHOWS THE SYMBOLS USED ON THE WASHING
MACHINE AND ALSO INDICATES THEIR FUNCTION. THE SYMBOLS MARKED
WITH (*) ARE ONLY USED ON SOME MODELS.
A
. PROGRAMME SELECTOR KNOB
To select the desired wash programme, turn this control
until the selector mark (L) coincides with the programme
number or symbol.
ALWAYS ROTATE the control in a clockwise direction, never
in an anticlockwise direction. Do not press the “on” button
(H) before selecting the programme
.
If you wish to modify the position of the control or select
another programme once a cycle has commenced, press
the Start/Stop key. Press again to recommence once the
modification has been completed.
f
. PROGRAMME STAGE DISPLAY
This displays the current programme stage throughout the programme
selected.
WASH: STOP WITH WATER IN DRUM:
RINSE: END OF PROGRAMME:
FINAL SPIN:
t
. TIME REMAINING DISPLAY
This displays the Approx. time remaining in minutes to the end of the
programme.
Programme duration is given AS A GUIDELINE ONLY. This time may vary
either way depending on the temperature selected, the amount ant type of
clothes and the installation conditions (water temperature, ambient
temperature, mains water pressure, etc.)
B
. TEMPERATURE SELECTOR KNOB
To select the desired wash temperature, turn this control
until the selector mark (L) coincides with the desired
temperature.
If you wish to carry out a cold wash, turn the knob until the
cold symbol coincides with the selector mark (L).
THE KNOB CAN BE TURNED IN BOTH DIRECTIONS.
Do not exceed the maximum temperature recommended
for each cycle in the table of programmes.
PROGRAMAS
TEMPERATURA
40
USE OF THE SELECTION CONTROLS
THE FOLLOWING TABLE SHOWS THE SYMBOLS USED ON THE WASHING
MACHINE AND ALSO INDICATES THEIR FUNCTION. THE SYMBOLS MARKED
WITH (*) ARE ONLY USED ON SOME MODELS.
*C
. SPIN SPEED SELECTOR KNOB
To select the final spin speed, turn this control until the selector
mark (L) coincides with the desired rpm.
This knob selects the final spin speed. To select a speed, press
down and turn until the desired speed coincides with the selector
mark.
The final spin cycle reaches the maximum speed selected in
non-delicate programmes. The middle and final spin cycles for
mixed, synthetics and delicate programmes is carried out at
400 r.p.m.
If you do not want a spin cycle, coincide the spin exclusion
symbol with the selector mark (L).
THE KNOB CAN BE TURNED IN BOTH DIRECTIONS.
*D
. SUPER-RINSE BUTTON
Pressing this button removes the last vestiges of soap powder from the
fabrics, as the rinses are done with more water. Programmes 1-2-3-4.
*D
. INTENSIVE WASH BUTTON
Use the intensive wash button for cotton programmes (1-2-3-4).
When the button is pressed, the selected temperature is kept constant
during all the phases of the wash cycle.
This feature combined with a sustained mechanical action results in
excellent washing results with resistant and particularly dirty fabrics.
D
. ANTI-CREASING BUTTON
This button works in all programmes except the 29-minute cycle.
It can be used to minimise wrinkling of fabrics during wash programmes.
The results obtained differ with each programme:
In programmes for NORMAL FABRICS, pressing this button will cause the
machine to stop on the last rinse, leaving clothes soaking in water.
To complete the programme and spin the clothes, press the button again to
release it.
In programmes for SYNTHETIC FABRICS, pressing this button will cut out
the intermediate spins and perform only one final spin at low sped, thus
minimising the stress suffered by fabrics.
In programmes for HIGHLY DELICATE FABRICS, pressing this button will
cause the machine to stop on the last rinse, leaving clothes soaking in water.
To complete the programme and spin the clothes, press the button again to
release it.
Do not press this button if the “vigorous spin” (normal fabrics)
programme is selected.
CENTRIFUGADO
SUPER
ACLARADO
LAVADO
INTENSIVO
PLANCHADO
FACIL
41
BIO 40ºC
USE OF THE SELECTION CONTROLS
THE FOLLOWING TABLE SHOWS THE SYMBOLS USED ON THE WASHING
MACHINE AND ALSO INDICATES THEIR FUNCTION. THE SYMBOLS MARKED
WITH (*) ARE ONLY USED ON SOME MODELS.
*D
. BIO 40ºC BUTTON
When this button is pressed, the machine stops in programmes for fast fabrics
(cotton) with water in the drum at a maximum of 40ºC. This enables the
enzymes in the washing powder to act more effectively.
This optimum wash system works in accordance with the requirements of
each user.
*D
. SPIN EXCLUSION BUTTON
This button excludes the spin cycle from the wash programme. This option is
recommended for special fabrics.
G
. ON/OFF PILOT LIGHT
H
. ON/OFF BUTTON
EXCLUSION
CENTRIFUGADO
MARCHA
PARADA
42
HEAVILY SOILED CLOTHES
NORMALLY SOILED CLOTHES
DELICATE COLOURS
DELICATE RINSES
DELICATE RINSE
GENTLE SPIN
DELICATE
WOOL
(“Machine washable”)
DELICATE SYNTHETICS
DELICATE RINSES
DELICATE RINSE
GENTLE SPIN
EMPTYING
Emptying only
The first program in each group is the longest and thus ensures the most effective wash at a given
temperature. The other programs should be selected for clothes which are only lightly soiled or are
particularly delicate.
TABLE OF PROGRAMMES
PROG.
SEL.
I
II
MAX.
LOAD
IN kg.
TYPE OF FABRIC
PROGRAMME FOR
WASHING POWDER LOAD
Programme
*
, as per IEN standard 60456.
FAST WASH PROGRAMME
Super-fast 29 minute cycle 2
From cold
to
…
50º
•
HEAVILY SOILED CLOTHES (PRE-WASH)
NORMALLY SOILED CLOTHES
FAST COLOURS
DELICATE COLOURS
BLEACH/ WHITENING
Organic stains
VIGOROUS RINSES
VIGOROUS RINSE
VIGOROUS SPIN
4,5
4,5
4,5
3,5
—
—
—
—
•
•
•
•
•
•
•
•
•
•
•
•
•
•
From cold
to
…
90º
From cold
to
…
90º
From cold
to
…
60º
From cold
to
…
40º
—
—
—
—
2
2
2
—
—-
—
5
6
7
•
•
•
•
•
•
•
•
From cold
to
…
60º
From cold
to
…
50º
From cold
to
…
40º
—
—
—
8
9
10
Z
1,5
1
1,5
—
—
—
—
•
•
•
•
•
•
•
•
MAX.
TEMP.
SEL.
ºC
From cold
to
…
40º
From cold
to
…
40º
From cold
to
…
30º
—
—
—
—
•
1
2
3
*
4
NORMAL FABRICS
SYNTHETIC FABRICS
HIGHLY DELICATE
FABRICS
43
NOTES:
1. For highly soiled clothes, it is advisable to reduce the load to no more than 3 kg.
2. For automatic whitening in programmes 1 and 2, pour bleach into the bleach
drawer .
3. The washing machine is designed to incorporate fabric softener automatically in the last
rinse of each washing cycle.
29-MINUTE FAST PROGRAMME
This programme completes a full wash cycle in 29 minutes for up to 2 kg
of clothes at 50ºC. Wash temperature can be lowered via the temperature
selector.
Pour washing powder into the pre-wash compartment (compartment 1).
The 29-minute fast programme can also be used as a pre-wash cycle with
particularly heavily soiled clothes. Just select the desired main programme
afterwards.
44
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14

Otsein-Hoover LB LTD1084 H User manual

Otsein-Hoover
Brand
Otsein-Hoover
Model
LB LTD1084 H
Category
Washing machines
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents