Workrite Ergonomics Laminated Modesty Panel Installation guide

Brand
Workrite Ergonomics
Model
Laminated Modesty Panel
Type
Installation guide
Workrite Ergonomics | 800.959.9675 www.workriteergo.com 1 of 2
Install Mounting Brackets to Modesty Panel
Attach Le & Right Mounting Brackets (B & C)
to Modesty Panel (A) using #10 × " Pan Head
Machine Screws(D) and tighten securely.
Verify that you have all the tools needed for the assembly
#2 tip Phillips screwdriver or drill/driver.
" drill bit
Pencil
or
Optional & Sold Separately
Cable Trough
Modesty Panel & Brackets
A Modesty Panel
Qty: 1 B Le Mounting Brackets
Qty: 2
Assembly & Installation Instructions:
Rigid Modesty Panel
D#10 × " Pan Head Machine
Screws
Qty: 8
E#12 × ¾" Pan Head Wood
Screws
Qty: 8
41", 53" & 65"
C Right Mounting Brackets
Qty: 2
Note: If installing while building a workcenter, it is easier to attach the Rigid Modesty Panel while workcenter is
upside down during installation.
ACC-MODPNL-XX-B3 ACC-MODMNTKIT-X
1
✓
A
D
D
B
C
Le Brackets
Right Brackets
Workrite Ergonomics | 800.959.9675 www.workriteergo.com 2 of 2
1500284 Rev B
Mark and Drill Pilot Holes
Note: It is easier to install the Modesty Panel
with the table assembly upside down on floor.
Locate the modesty panel by centering
le to right. Next, inset the modesty panel
from a minimum of " or inset as far as it
can be without contacting the moving leg
assemblies.
Mark the four key-hole locations as shown.
Drill the four marked locations with the "
drill bit to ¾" deep. You may wish to mark
your drill bit so you do not drill any more than
¾" deep and damage your worksurface top.
Do not drill all the way through
worksurface!
Attach to Worksurface at Keyhole Locations
Install four #12 × " Pan Head Wood Screws
(E) leaving a " space between the top and the
underside of the screw.
Place the Modesty Panel and Bracket using the
keyholes onto the four Wood Screws, push the
bracket into the keyholes and tighten securely.
Attach to Worksurface at Second Location
Drill the remaining four front mounting holes
with the " drill bit to ¾" deep.
Do not drill all the way through
worksurface!
Install the four remaining #12 × " Pan Head
Wood Screws (E) and tighten securely.
29"
½" min.
Leg
assembly
Mounting
Range
>¾"
2
3
4
a
a
a
a
a
a
b
b
b
b
b
b
b
c
c
Bottom of worksurface
E
E
  • Page 1 1
  • Page 2 2

Workrite Ergonomics Laminated Modesty Panel Installation guide

Brand
Workrite Ergonomics
Model
Laminated Modesty Panel
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents