2. Workrite Ergonomics
  3. 2-Leg 120 Deg. 34″-36″Wx23″-24″D, T343423T

Workrite Ergonomics 2-Leg 120 Deg. 34″-36″Wx23″-24″D, T343423T Installation guide

  • Hello! I've reviewed the mounting instructions for the Workrite Worksurface T343423T. This document provides guidance on attaching the base to both pre-drilled and non-pre-drilled surfaces, including instructions on how to place feet and avoid hazards. I'm ready to answer any questions you have about the installation process.
  • What is the recommended screw size for attaching the base to a Workrite pre-drilled worksurface?
    What is the installer's responsibility for non-rectangular worksurfaces?
    How should the frame set be positioned for a non-Workrite worksurface?
Workrite Ergonomics | 800.959.9675 www.workriteergo.com 1500318 Rev B
Worksurface Mounting Instructions:
2-Leg 120° 34"– 36" W × 23"– 24" D, T343423T
Attach Base to Worksurface
If you have a Workrite Pre-Drilled
Worksurface:
1.1 Position leg assemblies to align mounting holes in brackets to pre-drilled holes in worksurface as shown below.
Attach using #12 × ¾" Pan Head Laminate Top Screws included with your frame set. Continue to follow the
frame set instructions to complete workcenter assembly.
If you have a non-Workrite Worksurface:
1.1 Position Frame Set as shown, centered le to right.
1.2 Make sure feet do not exceed rear and side edge.
Note suggested placement of Control Box, Cable Spools and Switch. Continue to follow the frame set
instructions to complete workcenter assembly.
34” - 36” 34” - 36”
23” - 24”23” - 24”
DO NOT EXCEED
REAR EDGE
DO NOT EXCEED
FRONT AND SIDE EDGE
DO NOT EXCEED
FRONT AND SIDE EDGE
120°
CONTROL SWITCH
(OPTION - RIGHT)
CONTROL SWITCH
(OPTION - LEFT)
DO NOT EXCEED
REAR EDGE
GRAIN DIRECTION
28.20
35.45
15°
15°
Reference location
for front of foot.
Reference location
for front of foot.
Distance between brackets
29” D Foot
Cable Spool
location
Control Box
location
29” D Foot
15.51
5.60
15.51
5.60
1Note: Avoid trip or tip hazards!
For uniquely shaped, non-rectangular worksurfaces, it is the
installer's responsibility to position the worksurface to minimize
extended overhangs and position feet fully under the worksurface.
1.1
1.2
1.2
1.2 1.2
1.1
1.1
/