2. Workrite Ergonomics
  3. 2-Leg Equal Corners 46″-48″Wx23″-24″D, T464623

Workrite Ergonomics 2-Leg Equal Corners 46″-48″Wx23″-24″D, T464623 Installation guide

  • Hello! I have reviewed the Workrite mounting instructions for the T464623 worksurface. This document provides detailed guidance on how to properly attach the base to the worksurface, including instructions for both pre-drilled and non-pre-drilled surfaces. It also includes important safety guidelines to avoid trip hazards and extended overhangs, along with placement suggestions for control box, cable spools and switch. I'm ready to answer any questions you may have about setting up your workstation.
  • What screw type should be used to attach the base to the worksurface?
    What is the first step if I have a non-Workrite Worksurface?
    Where should i place the worksurface feet?
Workrite Ergonomics | 800.959.9675 www.workriteergo.com 1500304 Rev B
Worksurface Mounting Instructions:
2-Leg Equal Corners 46"– 48" W × 23"– 24" D, T464623
Attach Base to Worksurface
If you have a Workrite Pre-Drilled
Worksurface:
1.1 Position leg assemblies to align mounting holes in brackets to pre-drilled holes in worksurface as shown below.
Attach using #12 × ¾" Pan Head Laminate Top Screws included with your frame set. Continue to follow the
frame set instructions to complete workcenter assembly.
If you have a non-Workrite Worksurface:
1.1 Position Frame Set as shown, centered le to right.
1.2 Make sure feet do not exceed rear and side edge.
Note suggested placement of Control Box, Cable Spools and Switch. Continue to follow the frame set
instructions to complete workcenter assembly.
DO NOT EXCEED
SIDE EDGE
CONTROL SWITCH
(OPTION - RIGHT)
CONTROL SWITCH
(OPTION - LEFT)
DO NOT EXCEED
SIDE EDGE
41.57
29” D Foot
Distance between brackets
Cable Spool
location
Control Box
location
29” D Foot
34.31
Reference location
for front of foot.
Reference location
for front of foot.
GRAIN DIRECTION
15° 15°
10.91
10.91
3.91
3.91
46” - 48”46” - 48”
DO NOT EXCEED
REAR EDGE
DO NOT EXCEED
REAR EDGE
23” - 24” 23” - 24”
1Note: Avoid trip or tip hazards!
For uniquely shaped, non-rectangular worksurfaces, it is the
installer's responsibility to position the worksurface to minimize
extended overhangs and position feet fully under the worksurface.
1.11.1
1.21.2
1.2 1.2
1.1
/