Diebold Nixdorf CS D1000 Operating instructions

Operating and Installation

CINEO D1000

Questions and suggestions

CINEO D1000 - Operating and Installation 01750202272 C

Do you have ...

... any questions or suggestions

regarding this manual?

Please contact the following address

giving the order number of this manual

in your message:

Address:

WINCOR NIXDORF International GmbH

Handbuchredaktion R&D ACT 12

D - 33094 Paderborn

Germany

Fax: +49 (0) 52 51 693-62 09

E-mail: [email protected]

... any technical questions or problems?

Please contact your local representative.

April Edition 2013

CINEO D1000

Operating and Installation

CINEO D1000 - Operating and Installation 01750202272 C

All rights, including rights of translation

and rights of reproduction by reprinting,

copying or similar methods, even of

parts, are reserved.

Any violations give rise to a claim for

damages.

All rights, including rights created by

patent grants or registration of a utility

model or design, are reserved. Delivery

subject to availability; right of technical

modifications reserved.

All names of hardware and software

products mentioned in this manual are

trade names and/or trademarks of their

respective manufacturers.

This manual was

produced using paper

treated with chlorine-free

bleach.

01750202272 C CINEO D1000 - Operating and Installation I

Contents

Introduction ............................................................................................... 1

Symbols used in this manual ...................................................................... 1

Important safety precautions ...................................................................... 2

General power interruption ......................................................................... 5

Device overview ........................................................................................ 7

Controls....................................................................................................... 7

Installation and commissioning .............................................................. 9

Device dimensions ...................................................................................... 9

Operation and maintenance space ........................................................... 10

Securing the CINEO D1000 ...................................................................... 11

Drilling diagram .................................................................................... 11

Opening the CINEO D1000 ................................................................. 12

Screwing the CINEO D1000 ................................................................ 12

Closing the CINEO D1000 ................................................................... 13

Connecting the CINEO D1000 .................................................................. 14

Basic operation ....................................................................................... 15

Switching on the CINEO D1000 ................................................................ 15

Switching off the CINEO D1000 ............................................................... 15

LED indicators........................................................................................... 16

Setting the cassette version ...................................................................... 17

Setting the CINEO D1000 for standard and compact cassettes ......... 17

Setting the CINEO D1000 for Reject/Retract/Cat 3 cassettes............. 18

CINEO cassettes ...................................................................................... 19

Overview .............................................................................................. 19

CINEO cassettes concept ................................................................... 20

Manipulation monitoring ....................................................................... 21

Status messages of the LED ............................................................... 21

Standard cassette Basic/Midrange ...................................................... 22

Standard cassette Basic/Midrange opened .................................... 23

Compact cassette Basic/Midrange ...................................................... 24

Compact cassette Basic/Midrange opened .................................... 25

Standard cassette High End ................................................................ 26

Standard cassette High End opened .............................................. 27

Compact cassette High End ................................................................ 28

Compact cassette High End opened .............................................. 29

Contents

II CINEO D1000 - Operating and Installation 01750202272 C

Reject/retract/CAT 3 cassette .............................................................. 30

Banknote toning technique .................................................................. 33

Banknote toning technique processes ............................................ 34

Description of processes ........................................................... 35

In Branch (at the branch outlet) ............................................ 35

CIT (armored transport company) ........................................ 35

CIT with case (armored transport company with case) ........ 35

Standard drum (Standard) .................................................... 35

Limiting value ............................................................................. 36

Timer ......................................................................................... 37

Transport timer ..................................................................... 37

Open safe timer .................................................................... 37

Alarm timer ........................................................................... 37

Case timer ............................................................................ 38

Modes of the banknote toning technique - High End CINEO

cassette........................................................................................... 39

OFF mode (cassette configuration = In Branch *) ..................... 40

OFF mode (cassette configuration = CIT, CIT with Case) ........ 42

Transport mode ......................................................................... 43

Open shutter mode .................................................................... 44

Open safe mode ........................................................................ 45

Safe mode ................................................................................. 46

Trustee mode ............................................................................ 47

Inking mode ............................................................................... 48

Service note ............................................................................... 49

LED display – Power supply ................................................................. 50

Handling the CINEO cassettes ................................................................. 51

Safety instructions ................................................................................ 51

Inserting cassettes into the docking station ......................................... 53

Removing cassettes from the docking station ..................................... 54

Opening the cassette ........................................................................... 55

Closing the cassette ............................................................................. 55

Removing/refilling banknotes ............................................................... 57

Refill notes ........................................................................................... 59

Preparing banknotes ....................................................................... 59

Reject/Retract/CAT 3 cassette ............................................................ 66

Emptying the cassette ..................................................................... 66

Cleaning, Service and Maintenance ...................................................... 69

Cleaning the housing ................................................................................ 69

Replacing the connector module............................................................... 70

Contents

01750202272 C CINEO D1000 - Operating and Installation III

Appendix .................................................................................................. 73

Technical data .......................................................................................... 73

General installation conditions ............................................................. 73

Electrical characteristics of the supply network .............................. 73

Device conditions ........................................................................... 74

Installation specifications ................................................................ 75

Environmental conditions ............................................................... 76

Consumables ............................................................................................ 78

Orders .................................................................................................. 78

Connector module ............................................................................... 78

Emergency set Inking packaging, clothing .......................................... 78

Approved cleaning materials .................................................................... 79

Orders .................................................................................................. 79

Notes on using cleaning materials ....................................................... 79

General purpose cleaning material ...................................................... 80

Compliance with standards and approvals ............................................... 81

Standards met ..................................................................................... 81

Conformity ........................................................................................... 81

Notes concerning radio interference suppression and electrical

safety ................................................................................................... 81

Certification for data transmission ....................................................... 82

FCC rules and Canadian Standard ICES - 003 ................................... 82

UL 291, Level 1 (security Container) ................................................... 82

Environmental protection .......................................................................... 83

Environmentally and recycling-friendly product development .............. 83

Saving energy ...................................................................................... 83

Disposing of used consumables .......................................................... 83

Labels on plastic case parts ................................................................ 83

Returning, recycling and disposing of used units and

consumables ....................................................................................... 84

Contents

IV CINEO D1000 - Operating and Installation 01750202272 C

01750202272 C CINEO D1000 - Operating and Installation V

Abbreviations

B

BSMI Bureau of Standards,

Metrology and Inspection

C

CE Communauté Européenne

(European Community)

Declaration of Conformity

CEN Comité Européen de

Normalisation (European

Committee for

Standardization)

CFR Code of Federal

Regulation

CNS Chinese National

Standards

CSA Canadian Standards

Association

D

DT Data Transmission

E

EC European Community

EEC European Economic

Community

EMC Electromagnetic

Compatibility

EN European standard

F

FCC Federal Communications

Commission

G

GmbH Limited liability company

I

ICES Interference-Causing

Equipment Standards

IP International Protection

L

LED Light-Emitting Diode

T

TN network Power supply

network in accordance

with EN 60950

U

UL Underwriters Laboratories

Inc.

UPS Uninterruptible Power

Supply

Abbreviations

VI CINEO D1000 - Operating and Installation 01750202272 C

01750202272 C CINEO D1000 - Operating and Installation 1

Introduction

The CINEO D1000 is part of the CINEO product family.

The CINEO D1000 is a docking station which enables the authorized opening

and closing of CINEO cassettes.

CINEO cassettes that have a "mid-range" or higher configuration are able to

save data about cash management and logistics functions in an internal

memory, and they are also able to document tampering incidents

independently.

The CINEO D1000 allows this data to be read and written outside of an

automated teller machine.

In order to be able to operate the CINEO cassettes with the aforementioned

technical configuration, they must be opened in an authorized manner when

the remaining banknotes are removed and when the cassettes are filled; it is

also necessary to document the change in the internal cassette memory.

A PC with the installed "Cash Supply Manager (CSM)" software is required to

operate the CINEO D1000.

Symbols used in this manual

 Text following this mark represents an item in a list.

" " Text in quotation marks contains references to other chapters or sections in

this document.

 Paragraphs following this symbol are actions to be performed in the order

in which they are specified.

Text following this symbol should be given special attention in order to

avoid damage and injury.

i

This symbol identifies paragraphs which contain general notes to

facilitate use of the device and help avoid operating errors.

Important safety precautions Introduction

2 CINEO D1000 - Operating and Installation 01750202272 C

Important safety precautions

Please read the following notes carefully before doing any work on the

device.

This device complies with the relevant safety regulations for information

processing equipment.

 Unless otherwise stated, grasp the components only by the green ledge

when handling them.

 This device is equipped with a safety-tested power cable, which should

only be connected to a suitable, grounded electrical socket.

 Always hold the plug when removing the power cable. Never pull the cable

itself.

 Lay all connecting cables in such a way that they will not be stepped on or

tripped over, damaged or crushed in any way.

 Have damaged power cables replaced immediately.

 Make sure that there is always free access to the sockets used or to the

electrical circuit-breakers of the house installation.

 In case of an emergency (e.g. damaged housing, controls or power cables,

water or foreign objects in the device), proceed as follows:

Deactivate the device immediately by:

Switching off the automatic circuit breaker or removing the fuse insert

from the fuse holder in the distribution box of the building’s electricity

distribution cabinet.

Disconnecting the plug connectors of the power supply cables from the

grounded sockets in the distribution cabinet.

Interrupting the power connection, if there is one, between the UPS

(uninterruptible power supply) and the device (see section "General

power interruption").

Inform the customer service responsible for you.

 Never connect or disconnect data transmission lines during a

thunderstorm.

Introduction Important safety precautions

01750202272 C CINEO D1000 - Operating and Installation 3

 Only use accessories and extension components that have been approved

by us. Nonobservance can result in damage to the system or violations of

regulation concerning safety, radio interference and ergonomic

requirements.

 Only use cleaning agents approved by WINCOR NIXDORF

International GmbH to clean the device (see chapter "Appendix").

Important safety precautions Introduction

4 CINEO D1000 - Operating and Installation 01750202272 C

Repairs

Repair work may only be carried out by authorized personnel.

Unauthorized opening of the device or repair work carried out

improperly could result in considerable danger to the user.

In case of noncompliance, WINCOR NIXDORF International GmbH

excludes all liability.

Lithium batteries

The handling and the replacement should only be performed by

authorized service personnel who were trained by the

WINCOR NIXDORF International GmbH.

There is danger of fire or explosion if the batteries are handled

improperly. It is therefore important to note the following points:

– Avoid short circuits

– Never recharge the battery

– Avoid temperatures above +100 °C (+212 °F).

– Do not try to open the battery by force

– Do not allow the battery to come in contact with water or fire

The battery should only be replaced with the same or an equivalent

type recommended by WINCOR NIXDORF International GmbH (see

chapter “Appendix,” section “Consumables”).

Dispose of used batteries in compliance with national regulations and

the manufacturer's specifications.

Introduction General power interruption

01750202272 C CINEO D1000 - Operating and Installation 5

General power interruption

i

A general power interruption has the following effects:

– All current actions are immediately aborted.

– Data currently being evaluated can be faulty.

 Switch off the device by using the power switch at the rear of the device (1).

 Disconnect the rubber plug from the rear of the device (2).

Or:

 Disconnect the connector of the power supply cable from the on-site

electrical socket.

 Interrupt the power supply by switching off the circuit breaker or by

unscrewing the fuse in the building's distributor box.

General power interruption Introduction

6 CINEO D1000 - Operating and Installation 01750202272 C

01750202272 C CINEO D1000 - Operating and Installation 7

Device overview

Controls

Device front

5

4

3

4

1

2

6

7

1

Red LED 5

Cassette connector

2

Green LED 6

Cover

3

Top cover 7

Cassette selector switch

4

Cassette guiding elements

Controls Device overview

8 CINEO D1000 - Operating and Installation 01750202272 C

Rear of the device

1

2

3

4

1

Power cable connection 3

USB port

2

Power switch 4

Ventilation slots

01750202272 C CINEO D1000 - Operating and Installation 9

Installation and commissioning

Device dimensions

61.5

(2.42")

163.5

(6.44")

557

(21.93")

3

8

(13.31")

32.5

(1.27")

250

(9.84")

85 (3.35")

463

(18.23")

35

(1.38")

268

(10.55")

35

(1.38")

Operation and maintenance space Installation and commissioning

10 CINEO D1000 - Operating and Installation 01750202272 C

Operation and maintenance space

557 (21.93")

3

8

600 (23.62")

100

(3.94")

100

(3.94")

100

(3.94")

5

0

(

1

9

.

6

9

"

)

1538 (60.55")

5

0

(

1

9

.

6

9

"

)

Page is loading ...

Diebold Nixdorf CS D1000 Operating instructions

Diebold Nixdorf CS D1000 Operating instructions

Related papers

Other documents