Ampire LDS-NTG40-CP Installation guide

Brand: Ampire

Model: LDS-NTG40-CP

Type: Installation guide

LCD_IN

BENZ (NTG4.0) WIRING DIAGRAM

--LDS-NTG40-CP

Connect to CARPLAY-USB cable

Multimedia USB

WIFI ANTENNA

Connect to the Phone's original cable

Connect to original headunit

Connect to RGB output device

Optional cable

Power cable

RED---12V output for rear view camera

ORANGE--Reverse control cable (connect to reversing light) for AVM

/without reversing gridline

YELLOW---RCA Front/Rear video input(Connect to front

/rear view camera/360 AVM/DVR

Microphone cable

Microphone

Connect to the original

cable of the original headunit

Connect to CTRL

Connect to the LVDS ADAPATER'S video in

LVDS ADAPATER

Connect to the original

headunit's LVDS cable

Connect to the LVDS ADAPTER'S LCD IN

Touch panel cable

LCD OUT cable

AUX Connector

Pls plug it into the original AUX IN

port

Connect to the original

headunit LVDS port

REMARK:Please keep in the AUX interface when switch the CarPlay interface

3) Knob to control up/down/right/left/ok.

" button to switch MENU,short press"C

" button again,exit MENU.

Reset Dip Switch LED

(After changing the dip code,press "reset"or power-on again)

NTG4.0--DIP SWITCH SETTING

StatusDIP S/W

PIN 1,2 OFF/ON

OFF/ON

PIN 1

PIN 2

PIN 3

PIN 4

PIN 5

PIN 6

PIN 7

PIN 8

Description

NG/7inch Telescopic screen

NG/5.8inch screen

NG/7inch screen

NG/8inch screen for S class

Reversing gridline/Enable 360 panoramic

NG / NG

Rear view camera CVBS input / RGB input

NG / NG

After market rear camera / Original rear camera

If S class,pls use another cable

model No.:LXT1968BZS

Connect to AMI switch wire (Optional

cable) or Activate by professional PC

1) Long press and hold "

2)Short press "C" or 'TEL" button to open "Siri".

Ampire LDS-NTG40-CP Installation guide

Ampire LDS-NTG40-CP Installation guide

Ampire LDS-NTG40-CP Installation guide

Related papers

Other documents