Ampire LDS-A4-CP Installation guide

Type
Installation guide
LCD_OUT
Connect to gateway box port
Connect to the 4pin touch panel's
switch wiring,and then connect to
the touch panel.
Connect to the
original monitor's
cable.
ON
OFF
DIP S/W Staus Function
PIN 1 OFF/ON
PIN 2 OFF/ON
PIN 3 OFF/ON
PIN 5 OFF/ON
PIN 6 OFF/ON
PIN 7 OFF/ON
PIN 8 OFF/ON
Close front view camera/Open front view camera
Without touch panel/with touch panel
NG / NG
NG / NG
Connect to the Phone's original cable
Optional cable
Connect to RGB output device
Connect to the original headunit's big ISO
connector (The position of the blue inserts)
RED---12V output for rear view camera
ORANGE--Reverse control cable (connect to reversing light) for AVM
/without reversing gridline
YELLOW---RCA Front/Rear video input(Connect to front
/rear view camera/360 AVM/DVR
Stereo audio cable
BLACK---Stereo audio output
Microphone cable
Microphone
LCD OUT cable
Plug into the original
monitor's LVDS port
REMARK:Please keep in the AUX interface
when switch the CarPlay interface
1) Lo
ng press
and hold "MODE" b
utton to s
witch ME
NU, long
press"MODE" butt
on again,
exit the sw
itch MENU.
2)Sh
ort press V
oice control button
to open
"Siri".
3)Steering wheel controls & R
olle
r to c
ontro
l up/
down
/right/left/
ok.
Reset Dip Switch LED
PIN 4 OFF/ON
Reversing gridline/Enable 360 panoramic
Rear view camera CVBS input / RGB input
Aftermarket rear view CAM/Original rear view CAM
NG/Touch point coordinate correction,and PIN1"ON"
DIP SWIT
CH SETTING
(After changing the dip code,
press "reset"or pow
er-on again)
WIFI ANTENNA
Connect to CARPLAY-USB cable
Multimedia USB
RGB input cable
Update adapter
Power cable
Touch panel cable
Connect to cable pulled
from gateway box port
Audi (A4/Q5
) WIRING DIAG
RAM
---LDS-A4-CP
Pull out the
Blue connector
without no use
  • Page 1 1

Ampire LDS-A4-CP Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI