Page is loading ...
WIFI ANTENNA
Connect to CARPLAY-USB cable
Multimedia USB
RGB input cable
Update adapter
Power cable
LCD OUT cable
LCD IN cable
Microphone cable
DIP SWITCH SETTING
(After changing the dip code,press "reset"or power-on again)
Connect to the original cable
of the original headunit
Connect to original headunit
Connect to the Phone's original cable
Optional cable
Connect to RGB output device
RED---12V output for rear view camera
ORANGE--Reverse control cable (connect to reversing light) for AVM
/ without reversing gridline
YELLOW---RCA Front/Rear video input(Connect to front
/rear view camera/360 AVM/DVR
Stereo audio cable
Microphone
Connect to the original headunit's
cable(The original cable is gray).
Plug into the original headunit's LVDS port
REMARK:Please keep in the AUX interface when switch the CarPlay interface
(If there is no AUX status,pls activate it by computer)
Reset Dip Switch LED
ON
OFF
1) For A3/A4L/Q7 control panel,long press and hold "BACK" button to switch MENU,
long press "BACK" button again,exit the switch MENU.
2)Short press "MENU" button to open "Siri".
3)Knob to control up/down/right/left/ok.
CAR MODEL
OFF ON ON ON
PIN 4 OFF/ON
PIN 6 OFF/ON
PIN 7 OFF/ON
PIN 8 OFF/ON
Reversing gridline/Enable 360 panoramic
Rear view camera CVBS input / RGB input
NG/Touch point coordinate correction,and turn to "OFF"
Aftermarket rear view camera/Original rear view camera
Audi Q7
-MIB2/B9/B83 WIR
ING DIAGRAM
---LD
S-Q7-CP
PIN 1 PIN 2 PIN 3 PIN 5
ON OFF OFF OFF
ON OFF OFF ON
OFF OFF ON ON
2017 A4/Q7 8" ----CAN1(CAN+/CAN-)connect to original ISO
socket (pin6-Purple CAN+/pin12---Orange/brown CAN-)
2017 A4/Q7 7" ----CAN1 connect to original ISO socket gray (
pin6/pin12);CAN2 to pin1/pin7;Q7 MMI blue&white to I S O pin3
high-end A3(7") ----CAN1 connect to ISO socket's
(Gray socket)pin6&12,CAN2 connect to pin1&7
Low-end A3(5.8") -----CAN1 connect to ISO
socket's (Gray socket)pin6&12,CAN2 connect to pin1&7
/
