LCD_IN
BENZ (NTG4.0) WIRING DIAGRAM
--LDS-NTG40-CP
Connect to CARPLAY-USB cable
Multimedia USB
WIFI ANTENNA
Connect to the Phone's original cable
Connect to original headunit
Connect to RGB output device
Optional cable
Power cable
RED---12V output for rear view camera
ORANGE--Reverse control cable (connect to reversing light) for AVM
/without reversing gridline
YELLOW---RCA Front/Rear video input(Connect to front
/rear view camera/360 AVM/DVR
Microphone cable
Microphone
Connect to the original
cable of the original headunit
Connect to CTRL
Connect to the LVDS ADAPATER'S video in
LVDS ADAPATER
Connect to the original
headunit's LVDS cable
Connect to the LVDS ADAPTER'S LCD IN
Touch panel cable
LCD OUT cable
AUX Connector
Pls plug it into the original AUX IN
port
Connect to the original
headunit LVDS port
REMARK:Please keep in the AUX interface when switch the CarPlay interface
3) Knob to control up/down/right/left/ok.
" button to switch MENU,short press"C
" button again,exit MENU.
Reset Dip Switch LED
(After changing the dip code,press "reset"or power-on again)
NTG4.0--DIP SWITCH SETTING
StatusDIP S/W
PIN 1,2 OFF/ON
OFF/ON
OFF/ON
OFF/ON
OFF/ON
OFF/ON
OFF/ON
OFF/ON
OFF/ON
PIN 1
PIN 2
PIN 3
PIN 4
PIN 5
PIN 6
PIN 7
PIN 8
Description
NG/7inch Telescopic screen
NG/5.8inch screen
NG/7inch screen
NG/8inch screen for S class
Reversing gridline/Enable 360 panoramic
NG / NG
Rear view camera CVBS input / RGB input
NG / NG
After market rear camera / Original rear camera
If S class,pls use another cable
model No.:LXT1968BZS
Connect to AMI switch wire (Optional
cable) or Activate by professional PC
1) Long press and hold "
2)Short press "C" or 'TEL" button to open "Siri".
/
