2. Breezesta
  3. Ridgeline Rocking Bench

Breezesta Ridgeline Rocking Bench Assembly Instructions

  • I have reviewed the user manual for the BREEZESTA RIDGELINE RL-0204 Rocking Bench. This document provides detailed instructions on assembling the bench including a parts list and step-by-step guidance. I'm ready to answer your questions about the assembly process, required hardware, or any other aspect of the bench.
  • What screws are used to attach side assemblies to back assemblies?
    What type of screws are used to secure the slats?
    What hardware is required for attaching rockers?
Attached Side Assemblies to Back Assemblies using screws
(B) as shown.
Attach Front Rail using screws (B) with the metal support to the inside. Place Seat Supports in
place and screw through Back Assembly with screws (B) and through front rail with screws (A).
Fit seat slats into bench as shown. From the bottom side use uncolored screws (C) to secure
slats. Use screws (A) to attach Side Assemblies to Slats. Attach Rockers with screw (D) from
bottom.
OFO
Ver 13.0
D-4"uncolored
C-2"uncolored
A-1.5"colored
B-2.5"colored
B
RIGHT SIDE ASSEMBLY
BACK ASSEMBLY
STEP 1 LEFT SIDE ASSEMBLY
STEP 2
FRONT RAIL
SEAT SUPPORTS
36" BENCH (1)
48" BENCH (2)
60" BENCH (3)
B
A
B (from behind)
B
STEP 3
Place one end into
slot and bend slat
slightly to fit into
other end.
A
C's
(uncolored)
BREEZESTA tm
Recycled Poly Furniture
RIDGELINE ROCKING BENCH
LIST OF PARTS
Back Assembly (1)
Left End Assembly (1)
Right End Assembly (1)
Front Rail (1)
Seat Supports (see chart)
Seat Slats (5)
Rockers (2)
Hardware (see chart)
Insert Bit Tool (1)
Seat Supports
Bench Size
Screw "A"
Screw "B"
Screw "C"
60"
11
15
36"48"
1 2 3
10
10
7 8 9
9
5
Screw "D" 4 4 4
/