2. Breezesta
  3. Skyline backless Bench

Breezesta Skyline backless Bench Assembly Instructions

  • Hello! I've reviewed the user manual for the SKYLINE BACKLESS BENCH. This manual provides instructions for assembling the bench, detailing the parts and screws required for the 36", 48", and 60" versions. I can answer questions about the assembly process, part identification, and other relevant information within the document.
  • How many seat supports are needed for a 48" bench?
    What size are the colored screws labeled 'A'?
    What type of screws are used to secure the slats from the bottom side?
Attached Side Assemblies to Rail Assembly using screws (B)
as shown.
Fit seat slats into bench as shown. From the bottom side use uncolored screws (C) to secure
slats. Use screws (A) to attach Side Assemblies to Slats.
Place Seat Supports in place and using screws (A), attach the Rails as shown in the drawing
A F O
Ver 13.0
B-2.5"colored
A-1.5"colored
C-2"uncolored
B (from behind)
FRONT RAIL
STEP 1 A
SEAT SUPPORTS
36" BENCH (1)
48" BENCH (2)
60" BENCH (3)
STEP 2
RIGHT SIDE ASSEMBLY
B
LEFT SIDE ASSEMBLY
B
B
STEP 3
Place one end into
slot and bend slat
slightly to fit into
other end.
A
C's
(uncolored)
BREEZESTA tm
Recycled Poly Furniture
SKYLINE BACKLESS BENCH
LIST OF PARTS
Rails (2)
End Assembies (2)
Seat Slats (5)
Seat Supports (see chart)
Hardware (see chart)
Insert Bit Tool (1)
Seat Supports
Bench Size
Screw "A"
Screw "B"
Screw "C"
60"
8
15
36"48"
1 2 3
10
8
8 10 12
8
5
/