2. Right Weigh
  3. 201-EBT-30B-WB

Right Weigh 201-EBT-30B-WB Installation guide

  • Hello! I've reviewed the installation overview for the Right Weigh 201-EBT-30B-WB system. This document outlines the installation of the gauge and sensor kits for tractor and straight trucks with walking-beam suspensions. It details the mounting locations for sensors A, B, and C, as well as the proper gauge configuration for accurate readings. I can help with questions about the sensor placement, suspension compatibility, or the gauge settings described in this document.
  • What should the gauge be set to detect?
    Where should sensor 'A' be installed?
    Where should sensors 'B' and 'C' be installed?
INSTALLATION OVERVIEW
201-EBT-30B-WB
This installaon overview is not a substute for reading the product manuals
WHAT’S INCLUDED
PP-003-0060 REV D
CONTACT US!
Right Weigh, Inc.
(888) 818-2058
www.rwls.com
[email protected]
Follow Us!
1 x 201-217-30 - Gauge and mounng bracket
2 x 218-SK - Weld strain sensor installaon kit
SENSOR CONFIGURATION
The gauge should be set to detect 3 Spring Sensors. See Spring Suspension
Gauge manual for more informaon on how to set the sensor configuraon.
www.rwls.com
ON/OFF
HOLD 3 SECONDS
CALIBRATE
C
HIGH
1C
LOW
234
ENTER
MENU
i
EL-003-0004
1 2 3 4 C/H C/L - KG LBS
Scan here to see addional resources on our
website including full installaon manuals,
quick set up guides, and video tutorials!
APPLICATIONS
Tractor or Straight Truck with Walking-Beam Suspension
Suspension Compability:
This kit is compable with the drive axle suspension models listed below, however it may also fit others that are not listed. Please refer to the notes
next to your model for any specific installaon concerns.
Make Model Applicaon Notes
Chalmers 800
Hendrickson Haulmax
Hendrickson HN
Hendrickson RS Not for use on models with cast equalizing beams.
Hendrickson RT Not for use on models with cast equalizing beams.
Other models Not for use on models with cast equalizing beams. Check for clearance between top of equalizing
beam and vehicle frame to ensure sensor will not be damaged during suspension arculaon.
C
B
A
1 x 221-SK - Epoxy strain sensor installaon kit
Sensor Locaon:
Strain sensor “A” should be installed on the top, center of the steer axle
using the 221-SK kit. Sensors “B” and “C” from the 218-SK installaon
kits should be installed on the top of each equalizing beam with one
mounted near the front of the vehicle and the other mounted towards
the rear (see image to the right).
Mode:
Set the gauge to Front 1 Back 2 (F1b2) mode. This mode measure
sensor “A” as one axle group weight and sensors “B” and “C” as another
axle group weight. See Spring Suspension Gauge manual for
informaon on how to set the mode.
/