Herman Miller Cosm Stool, Cosm Chairs Product Instructions

Hello! I've reviewed the instructions for the HermanMiller Cosm Chair Height Adjust Assembly replacement. This document provides a detailed guide on how to disassemble and reassemble the height adjust control, including the removal of antler covers, tilt housing, and cable actuator housing. I’m ready to assist you with any questions you have about the process.
What tools are required for the height adjust assembly replacement?

How do I remove the lower antler cover?

How do I install the new height adjust cable assembly?

Tools Required

HermanMiller

Cosm Chair Height Adjust Assembly

Replacement

How to dissemble and assemble your

height adjust assembly.

Flat Screw Driver # Screw Driver

Step 3

. Using flat screw driver, unhook the four tabs of upper antler cover

and take out.

Step 2

Step 1

. Insert the flat screw driver into the lower antler cover hole and gently pry

down until both sides are released.

. Using T- Torx bit, unscrew the attachment bolt and remove the old

height adjust control down.

. Pull and take out the lower antler cover.

T- Torx Bit

1HermanMiller for Cosm chair Dissembly and Reassembly Instructions1BKJD3 rev A

2HermanMiller for Cosm chair Dissembly and Reassembly Instructions1BKJD3 rev A

Step 4 Step 5

Step 6

. Using flat screw driver, li up and pull out the tilt housing cover. . slide in the flat screw driver from back of the tilt and catch the back edge

of old cable actuator housing.

. To Install new height adjust cable assembly, make the fork edge of the

cable actuator hooked under the lip inside the tilt.

. Using # screw driver, pry down on the top of the housing and make sure

not to impact with cable.

. Pry down and pop the control loose to remove.

New Height Adjust Assembly Installation. Step 7

. Slide the tilt housing cover in and make the center post on

the cover snaps into tilt tab.