2. Herman Miller
  3. Cosm Stool

Herman Miller Cosm Stool, Cosm Chairs Product Instructions

  • Hello! I've reviewed the Disassembly and Reassembly Instructions for the HermanMiller Cosm 1BKJD5 Chair Tilt Housing Cover. This document provides detailed steps on how to remove the old cover and install a new one using a flat screwdriver. I'm ready to help you with any questions you have about this process.
  • What tool is required for the disassembly?
    What is the first step in removing lower antler cover?
    How to remove the old tilt housing cover?
Tools Required
HermanMiller
Cosm Chair Tilt Housing Cover
Replacement
How to dissemble and assemble your
tilt housing cover.
Step 1
1.1 Insert the flat screw driver into the lower antler cover hole and gently pry
down until both sides are released.
1.2 Pull and take out the lower antler cover.
Flat Screw Driver
Step 2 Step 3
2.1 Using flat screw driver, unhook the four tabs of upper antler cover
and take out.
3.1 Using flat screw driver, li up and pull out the old tilt housing cover and
remove it.
1HermanMiller for Cosm chair Dissembly and Reassembly Instructions1BKJD5 rev A
2HermanMiller for Cosm chair Dissembly and Reassembly Instructions1BKJD5 rev A
Step 6
6.1 Install the lower antler cover, by putting the back hooks into
casting holes rst and snap the rear edge of the cover down.
Step 5
Step 4
New Tilt Housing Cover Installation.
5.1 Install the upper antler cover inside the depression in the castings
and snap into place.
4.1 Slide the new tilt housing cover in and make the center post on
the cover snaps into tilt tab.
/