2. Herman Miller
  3. Cosm Stool

Herman Miller Cosm Stool, Cosm Chairs Product Instructions

  • Hello! I've reviewed the instructions for the HermanMiller Cosm Fixed Arm Replacement. I understand the steps involved in disassembling the old arm, installing the new one using a shoulder bolt, and the required torque settings. I am ready to assist you with any questions you might have about this procedure.
  • What tools are required for the arm replacement?
    What should be done with the old arm and bolt?
    Which bit do I need to install the fixed arm?
Tools Required
HermanMiller
Cosm Chair Fixed Arm Replacement
How to dissemble and assemble your
xed arm.
Step 2
Parts Included
Step 1
. Using a power driver with one* of the bits listed above, remove the
existing arm from the chair.
. Dispose the arm and bolt.
*The bolt used at this joint may require a mm hex, mm hex or
a T- torx bit.
. Place the shoulder bolt into the new xed arm.
Power Driver 6mm
Hex Bit
6” Long
T-
Torx Bit
6” Long
mm
Hex Bit
6” Long
New Fixed Arm Installation
Shoulder Bolt ()Fixed Arm
1HermanMiller for Cosm chair Dissembly and Reassembly Instructions1BKJD9 rev C
2HermanMiller for Cosm chair Dissembly and Reassembly Instructions1BKJD9 rev C
Step 3
. Install the xed arm using the T- torx bit.
. Torque to  in-lbs.
/