2. Herman Miller
  3. Cosm Stool

Herman Miller Cosm Stool, Cosm Chairs Product Instructions

  • Hello! I've reviewed the instructions for the HermanMiller Cosm No Arm Plug replacement. This document outlines everything you need to know to safely remove the old plug and install the new one, detailing the tools, parts and steps required. I am ready to answer any questions you may have about the procedure.
  • What tools are required for the no arm plug replacement?
    What parts are included in the no arm plug replacement kit?
    What is the torque specification for installing the no arm plug?
Tools Required
HermanMiller
Cosm Chair No Arm Plug Replacement
How to dissemble and assemble your
no arm plug.
Step 1
Step 2
Parts Included
. Using a power drive with one* of the drive listed above, remove the no
arm plug from the chair.
. Dispose of plug and bolt.
* The bolt used at this joint may require a mm hex or a T- torx bit.
. Place the new shoulder bolt into the new no arm plug.
Power Driver T-
Torx Bit
6” Long
6mm
Hex Bit
6” Long
No Plug () Shoulder Bolt ()
New No Arm Plug Installation
1HermanMiller for Cosm chair Dissembly and Reassembly Instructions1BKJD8 rev C
2HermanMiller for Cosm chair Dissembly and Reassembly Instructions1BKJD8 rev C
Step 3
. Install the no arm plug using the T- torx bit.
. Torque to  in-lbs.
/