Norac 7470BC-02 Installation guide

  • I've reviewed the NORAC 44973 Bracket Installation Manual and I'm ready to assist you. This document provides comprehensive instructions for installing the main lift sensor bracket, including mounting procedures, electrical connections, and software setup. It emphasizes the importance of proper sensor placement and avoiding obstructions. Feel free to ask any questions about the installation process or device functionality.
  • What should I do before installing the system?
    What should I apply on threaded parts during installation?
    What is minimum distance between sensor in lowest position and the ground?
    What should i do before powering the control panel on?

MainLiftOption
44973Bracket
InstallationManual
Copyright2023byTopconAgricultureCanada
ReorderP/N:7470BC02INSTRevB(MainLiftOption44973Bracket)
NOTICE:TopconAgricultureCanadareservestherighttoimproveproductsandtheirspecificationswithoutnoticeandwithouttherequirementtoupdate
productssoldpreviously.Everyefforthasbeenmadetoensuretheaccuracyoftheinformationcontainedinthismanual.Thetechnicalinformationinthismanual
wasreviewedatthetimeofapprovalforpublication.
WWW.NORAC.CA
PRECISIONDEFINED
Contents
Introduction..........................................................................................................................1
MainLiftSensorInstallation..................................................................................................2
ElectricalInstallation.............................................................................................................4
SoftwareSetup......................................................................................................................5
CableDrawings......................................................................................................................6

WWW.NORAC.CA
PRECISIONDEFINED

Page1
Visitwww.solutions.norac.caformoresystem
installationandtroubleshootinginfo.
1 Introduction
Pleasetakethetimetoreadthismanualcompletelybeforeattemptingtoinstallthesystem.Athorough
understandingofthismanualwillensurethatyoureceivethemaximumbenefitfromthesystem.
Yourinputcanhelpmakeusbetter!Ifyoufindissuesorhavesuggestionsregardingthepartslistorthe
installationprocedure,pleasedon’thesitatetocontactus.
1.1. ListofParts
ItemPartNumberNameQuantity
B2144973BRKT,SENSORMNTLOWPROLRGFLNGE1
C074322001CBL,NETWORK14AWG1M1
E0750300MAXSENSOR‐CLIP/FOAM1
E1243764NETWORKCOUPLER2WAY1
M037470BC02INSTMANUALINSTALLATIONMAINLIFTOPTION44973BRACKET1
Everyefforthasbeenmadetoensuretheaccuracyoftheinformationcontainedinthismanual.Allparts
suppliedareselectedtospeciallyfitthesprayertofacilitateacompleteinstallation.However,Topconcannot
guaranteeallpartsfitasintendedduetothevariationsofthesprayerbythemanufacturer.
Pleasereadthismanualinitsentiretybeforeattemptinginstallation.
Donotusehighspeedpowertools/drillswheninstallinghardware.
TheuseofdielectricgreaseisnotrecommendedonanyTopconelectricalconnections.
ToensureallstainlesssteelhardwaredoesnotgallorseizeapplyalightcoatingofthesuppliedPermatex
Antiseizegreasetoallthreadedpartsuponinstallation.PermatexAntiseizelubricantispreferred,butother
similarantiseizeproductsmaybeused.
WWW.NORAC.CA
PRECISIONDEFINED

Page2
Visitwww.solutions.norac.caformoresystem
installationandtroubleshootinginfo.
2 MainLiftSensorInstallation
1. Thereareavarietyofwaystomountthemainliftbracketonmostsprayers.Thebracketshouldposition
thesensorapproximatelyinthecenterofthesprayer,forwardoftheboom.Anexampleofthismounting
isillustratedinFigure2.
 
Figure1:BracketMountingExample
2. Mounttheultrasonicsensortothemainliftbracket.TorquetheM8nutto108inlb(12Nm).Runthe
sensorcablethroughholeandbehindthebracket.
 
Figure2:ExampleMountingoftheMainLiftBracket
Avoidmountingthemainliftsensoroverornearawheeltrack.Measurementsfromthewheeltrackdonot
provideanaccuratecropheightandwillcausemeasurementandcontrolerror.
Ensurethebracketdoesnotcollidewithanyotherpartofthesprayerthroughoutthefullrangeofmainlift
motion.
Front
WWW.NORAC.CA
PRECISIONDEFINED

Page3
Visitwww.solutions.norac.caformoresystem
installationandtroubleshootinginfo.
2.1. UltrasonicSensorMountingGuidelines
Thefollowingguidelineswillensureoptimalsensorperformanceandpreventsensormeasurementerror.
1. Initslowestposition,thesensormustbe9inches(23cm)ormorefromtheground.
2. Ensurethattherearenoobstructionswithina12inchdiametercircleprojecteddirectlybelowthecenter
ofthesensor.
3. Thesensorshouldbeapproximatelyverticalatnormaloperatingheights.
Figure3:SensorMountingGuidelines
Figure4:BracketMountingGuidelines
2.2. LowProfileBracketMountingGuidelines
1. Minimizethedistancebetweentheboltstopreventbendingthebracketandpreventthebracketfrom
looseningovertime.
2. Ensurethebracketismountedtightagainstthebottomoftheboom,minimizingthedistancebetweenthe
boomstructureandtheangledflange.
Aproblemcanariseifasensorisnotmountedcorrectly.Itispossibleforthesensortoreadoffoftheboom
insteadoftheground.Thismayonlybecomeapparentoncethecontrolsystemisswitchedfromsoiltocrop
mode.
Alsobecarefulthatthesensorbracketdoesnotcollidewithanyotherpartoftheboomwhentheboomis
foldedtotransportposition.Ifpossible,mountthesensorbracketswhiletheboomsarefoldedtoensure
theywillnotcauseinterference.
WWW.NORAC.CA
PRECISIONDEFINED

Page4
Visitwww.solutions.norac.caformoresystem
installationandtroubleshootinginfo.
3 ElectricalInstallation
1. Connectthemainliftsensortothe8waycoupler(E11)usingcableC07andthe2waycoupler(E12).Cable
C07anditemE12maynotbeneededifthe8waycouplerismountedcloseenoughtothemainliftsensor.
Figure5:ElectricalConnections
Onlycomponentsshowninblackareincludedwiththiskit.
WWW.NORAC.CA
PRECISIONDEFINED

Page5
Visitwww.solutions.norac.caformoresystem
installationandtroubleshootinginfo.
4 SoftwareSetup
1. Startupthesprayerandtestthesprayer’sfunctionality.Thecontrolpaneldoesnotneedtobepowered
onfortheoriginalswitchestofunction.
Confirmthatthecablingandhosesareagreeabletotheentirerangeofmotion.
2. Ifanyfunctionsdonotwork,reviewthismanualtocheckforproperinstallation.
3. Turnonthepowerforthecontrolpanelusingtheswitchonthesideofthechassis.
4. RefertotheSprayHeightControlOperator’sManualtorunanautomaticinstall.
WWW.NORAC.CA
PRECISIONDEFINED

Page6
Visitwww.solutions.norac.caformoresystem
installationandtroubleshootinginfo.
5 CableDrawings
5.1. ITEMC07:4322001‐CBL,NETWORK14AWG1M


WWW.NORAC.CA
PRECISIONDEFINED

Page7
Visitwww.solutions.norac.caformoresystem
installationandtroubleshootinginfo.
 Notes
TOPCONAgricultureCanada
3702KinnearPlace
Saskatoon,SKS7P0A6
TOPCONAgricultureAmericas
W5527Hwy106
FortAtkinson,WI53538
TOPCONPrecisionAgricultureEurope
Avenidadelaindustria,
35,TresCantos,España
Spain
Support
Phone:8889799509
Email:[email protected]
Web:www.norac.ca

/