2. KLUS
  3. K-10
K-10

KLUS K-10 User manual

  • Hello! I'm here to assist you with your questions about the K-10 24340 mounting bracket. I've reviewed the provided mounting instructions, which cover the proper installation method using screws, along with the power supply and fixture connection. I can help you understand the mounting process and key aspects of the product.
  • What is the product reference number?
    What type of power supply is needed?
    How many mounting brackets are recommended for a 1 meter fixture?
K-10 Mounting bracket – mounting instructions
1
NOTE! All LED tapes must be connected to a 12 V or 24 V power supply.
IMPORTANT: Not all possible mounting procedures are presented here.
More mounting procedures and related accessories can be found at www.KlusDesign.eu
Drawings of extrusions and accessories in these instructions are simplied and only
approximate the actual shapes.
*The full range of accessories and electronics is available at www.KlusDesign.eu
www.KlusDesign.eu
1. K-10 Mounting bracket (ref. 24340)
2. Screw
3. Lighting xture
4. Power supply (12 V / 24 V)
1.
3.
2.
4.
CLICK!
2
K-10 Mounting bracket – mounting instructions
www.KlusDesign.eu
Connect the xture (3) to the power
supply (4) and mount it in the brackets.
Screw the K-10 mounting brackets (1)
to the surface with the use of screws (2).
the brackets must be alligned
in a straight line.
It is recommended to use:
2 mounting brackets for 1 m of xture
4 mounting brackets for 2 m of xture
5 mounting brackets for 3 m of xture
NOTE! It is necessary to use countersunk
screws dedicated to the particular type
of surface. Diameter of the screws
cannot exceed 3 mm / 0.12”.
I
II
3.
1.
2.
1.
2.
4.
/