*The full range of accessories and electronics is available at www.KlusDesign.eu
www.KlusDesign.eu
NOTE! All LED tapes must be connected to a 12 V or 24 V power supply.
IMPORTANT: Not all possible mounting procedures are presented here.
More mounting procedures and related accessories can be found at www.KlusDesign.eu.
Drawings of extrusions and accessories in these instructions are simplied and only
approximate the actual shapes.
1
PDS-STN-ALFA Bracket - mounting instructions
1. PDS-STN-ALFA Mounting bracket (product made to order)
2. Screw*
3. Lighting xture*
4. Power supply (12 V / 24 V)*
P. 2
P. 3
1.
2.
3.
4.
CLICK!
www.KlusDesign.eu 2
PDS-STN-ALFA Bracket - mounting instructions
a) Mounting the xture into mounting brackets screwed to the surface
Feed the power cable from the xture
to the power supply (4).
Snap the lighting xture (3) into the
brackets.
Attach the mounting bracket (1) to the
surface with appropriate screws (2) (not
provided).
Ia
IIa
IIIa
2.
1.
4.
3.
CLICK!
www.KlusDesign.eu 3
PDS-STN-ALFA Bracket - mounting instructions
b) Installation of the xture with brackets mounted on the prole
Feed the power cable from the xture
to the power supply (4).
Attach mounting brackets (1)
to the xture (3).
Attach the xture with brackets to the
surface with appropriate screws (2)
(not provided).
Top view
Ib
IIb
IIIb
3.
1.
4.
2.
-
1
-
2
-
3
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Eaton PRO III L-850A RCL Owner's manual
-
Eaton Crouse-Hinds L-850 A User manual
-
Toshiba S20LP User manual
-
Color Kinetics ColorBlast 6 User manual
-
Cooper L-852G User manual
-
-
-
Alfa APS08ATH Datasheet
-
UMX FLIP Specification
-
Philips iColor Cove QLX User manual
